What does fi mean on a Honda?
Honda PGM-FI – Programmed Fuel Injection explained.
What is the Mil code on a Honda CBR 600 F4i?
All owners of the Honda CBR 600 F4i will sooner or later have to deal with such a problem as the flashing of the FI (MIL) light. These short and not much longer blinks are the same error codes.
How to check Honda CBR 600 f4i-kappa motorbike?
• Hard start at a low temperature (simulate using numerical values; 90″C/194T) • Poor engine response when operating the throttle quickly (simulate using numerical values; Throttle opens 0″) Turn the ignition switch to “OFF”. Disconnect the MAP sensor 3P connector. Check for loose or poor contact on the MAP sor connector.
When to use code 12 on Honda CBR 600?
When the indicator lights for 1.3 seconds it is equivalent to 10 blinks For example, a 1.3 second illumination and two blinks (0.5 second X 2) of the indicator equals 12 blinks. Follow code 12 on page 5-26. • When more than one failure occurs, the MIL shows the blinks in the order of lowest number to highest number.
What does PGM-FI Mil stand for on Honda CBR 600?
• The PGM-FI MIL denotes the failure codes (the number of blinks from 0 to 33). When the indicator lights for 1.3 seconds it is equivalent to 10 blinks For example, a 1.3 second illumination and two blinks (0.5 second X 2) of the indicator equals 12 blinks.
When does the fi light come on on a Honda CBR?
While the engine is running and the motorcycle is being used, the FI light will come on and stay on. When the motorcycle is on its side stand and the is running below 5000 revs the FI light will flash, the pattern of the flashes indicating the code for the fault the ECM has identified.
What’s the failure code for a Honda CBR 600 F4i?
Connection: Yellow/Red (+) – Ground {-) Standard: 4.75-5.25 V Turn the ignition switch to “OFF”. Disconnect the MAP sensor 3P connector. Turn the ignition switch to “ON”. Measure the voltage at the wire harness side connector. Open or short circuit in Yellow/Red wire. Loose or poor contact on the ECM connectors.
When does the fault code flash on Honda CBR XX?
If there are no stored codes the FI light will come on and stay on. If there are stored fault codes, the FI light will flash. The fuel injection system warning light uses long ( 1.3 second ) and short ( .5 second ) flashes to give out the fault code.
When the indicator lights for 1.3 seconds it is equivalent to 10 blinks For example, a 1.3 second illumination and two blinks (0.5 second X 2) of the indicator equals 12 blinks. Follow code 12 on page 5-26. • When more than one failure occurs, the MIL shows the blinks in the order of lowest number to highest number.