What does F08 mean on Indesit washing machine?
If an Indesit or Hotpoint washing machine is flashing an LED 8 times, or is displaying the error code F08, this usually indicates the following. “Heater relay can’t be activated” or “heater relay stuck”.
What does fo2 mean on a Indesit washing machine?
Motor circuit fault Issue
F02 — Motor circuit fault. Issue: Intermittent or no drum rotation during wash cycle. Advice: We recommend you call our customer service centre to book an engineer on: 0344 822 4224. F03 — Temperature sensing fault. Issue: Washing Machines not heating on wash or dry settings.
What is F08 error?
F08 indicates that the heater is an open circuit so check the heater for continuity with a meter. F12 relates to an element short or the heater has failed completely so replace if necessary. Fault code F09 on some machines is an overflow error, which indicates that water has been found on the base of the appliance.
What does F mean in a washing machine?
The F indicates that the washer control detected a component problem. If the F code was caused by excessive suds preventing the washer from draining, you may be able to shut the door and run a drain/spin cycle to remove the water from the washer.
What does F 01 mean on a washer?
failed electronic machine control board
The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes. Be sure to unplug the washer before accessing internal components.
What does F 01 mean on a washing machine?
What does F8 mean on Hotpoint washing machine?
Heater relay
F8 – Heater relay stuck. As above this fault indicates a problem with the heating system in your machine and could also be caused by the pressure switch.
How do I fix the F error on my Whirlpool washer?
DIY Repair
- Unplug the washing machine for 2 minutes and then plug it back (it will help the appliance re-conduct self-diagnostics and conclude that there is no breakdown);
- Press the START and PAUSE buttons simultaneously and hold them for 1 minute to clear the error code.