What does AC compressor clutch 2 wires hook up to?
I have a 1987 Dodge Dakota SE 3.9 V6 with factory air. The AC compressor clutch will not activate when plugged into the original harness, even though power is coming from the dash switch. What does the second wire do? Is it just a ground wire no longer grounded? . . . . Click to expand…
Where does the wire go on an A / C compressor?
This wire attaches to the compressor at a socket or protruding blade connector. The wire will have an adapter plug on the end of it, and if it does not, one must be attached to it.
How do you connect a jumper wire to a compressor?
Unplug the single wire connector on the front side of the compressor. Take the fused jumper wire and connect its one end to that side of the wire connector that was connected to the compressor. Attach the other end of the jumper wire to the positive terminal of the battery.
Do you replace the compressor or buy a new unit?
It’s tough. Your AC isn’t working and you find out that the compressor needs replacing. And, jeez it’s expensive! So should you just go ahead and replace the compressor, or should you get a new outside unit instead? Just so you don’t get ripped off, don’t assume that the first diagnosis is 100% accurate.
I have a 1987 Dodge Dakota SE 3.9 V6 with factory air. The AC compressor clutch will not activate when plugged into the original harness, even though power is coming from the dash switch. What does the second wire do? Is it just a ground wire no longer grounded? . . . . Click to expand…
How does the a / C compressor connector work in a car?
The A/C compressor connector links the compressor to the vehicle’s electrical system. If the connector fails, the compressor will not activate when the A/C is switched on in the cabin.
Do you need a 220 Volt plug for an air compressor?
To give you a general idea, let’s say you just bought an air compressor from Home Depot. It requires 220 volts but the plug only has three prongs. You’ll have the two that look alike and will be the two separate hots and other round looking on would be the ground.
Where is the AC switch on the back of the compressor?
To install a switch now, you will have to evacuate the system, install the switch and than recharge it. By the way, my online database is showing that the 97’s high pressure cut out switch is located on the compressor and the low pressure switch is on the accumulator.