What do I do if there is no spark on ignition coil?
Press the auto zero button to zero Probe. Clamp current Probe around the b+ side or the Control side of ignition coil. Do not clamp around both. If coil is difficult to access, it may be possible to check coil current at the fuse box, if applicable. Verify that Probe jaws are fully closed.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
Where does the spark come from in the ignition coil?
This high voltage is required to overcome the greatest KV requirement in the secondary (normally the spark plug gap) this high voltage is transmitted from the coil to the spark plugs through a coil wire, dist cap, rotor and spark plug wires. Component Test Meter can be used to view secondary ignition waveforms.
How to reset the engine control module ( ECU )?
The 2 most common ways to reset your car computer is by either unplugging the battery or by resetting the fuse related to the engine control module Will disconnecting battery reset ECU? Disconnect the battery and Switch the ignition key to the on position for about 15 minutes should reset the ECU
What to do if there is no spark at the ignition coil?
Check for voltage output at the ignition coil. Disconnect the ignition coil wire from the distributor and install the spark tester to the wire and ground the tester to the engine. Crank the engine for a few seconds. If there’s spark, the problem is with the distributor cap or rotor.
Can a car not start with a faulty coil pack?
The coil pack within your car is an important piece of the ignition system. Without the coil pack properly functioning, the ignition system won’t work, and your car won’t start. Although numerous parts of your car are imperative and must work together in order to function at an optimal level, the coil pack may be one of
When did I replace spark plug and coil?
Replaced coil and spark plug, still no spark. also disconnected green brake wire. What else is there? Submitted: 10 years ago. Category: Small Engine Experience: Outdoor Power Equipment technical trainer since 1990, covering eight states. Hello, and thank you for choosing JustAnswer.
What should I do if my spark plug is bad?
It should draw the screwdriver from about a 1/2″ away. Finally, take the coil off and clean the connection points where the coil and engine meet with a bit of sandpaper, both the coil and the engine. If these steps don’t solve the problem, you have a bad ignition module that will need to be replaced. Sometimes even new ones are bad.