What causes the clutch to lose traction at top speed?
If there is severe dishing down low near the center of the drive clutch faces, the belt may actually bark upon start up as it slips into the deep groove and momentarily loses traction. At top speed the belt will eventually wear a groove around the upper portion of the clutch face too.
Which is the latest belt drive, Ltd?
Be sure to check out the GMA by BDL line of motorcycle brakes and controls. The latest member of the Belt Drives, LTD. family is Blower Drive Service. Look for new and exciting changes in the very near future! Love your ride? Proud of your bike?
What are the signs of impending drive clutch failure?
Another symptom of impending drive clutch failure is poor transition from top speed to hill pulling. You are riding along on level or near level ground at top speed; the engine is running fine with reasonable power.
When did golf cart clutches start to wear out?
After 1981 all golf cart clutch systems were dry, except the Yamaha clutches which could be greased but they were never really a ‘wet’ clutch (don’t over-grease them-one or two pumps of grease is all they need). Another common clutch problem is the ‘soft’ clutch faces wearing out due to the constant action of the belt edges scrubbing against them.
What kind of steel is belt drive clutch plate made of?
OEM Replacement Clutch Kits | Belt Drives, LTD. All clutch plates are made of either 6061 T6 or high-tempered steel with our own race proven aramid fibers material. Each plate design was tested so that maximum performance is achieved.
Where can I find primary belt drives for Harley?
You are here: Home > Mid-USA Parts- Clutches and Driveline > Primary Belt Drives and Parts You are here: Home > Mid-USA Parts- Clutches and Driveline > Primary Belt Drives and Parts Copyright 1999-2021 American Legend Motorcycles. All rights reserved.
Be sure to check out the GMA by BDL line of motorcycle brakes and controls. The latest member of the Belt Drives, LTD. family is Blower Drive Service. Look for new and exciting changes in the very near future! Love your ride? Proud of your bike?
What kind of belt drive does a BDL use?
BDL ESW-1 CLUTCH PART,C CLIP STEP WASHER FITS BDL BELT DRIVES W/CL SEE CATALOG FOR FIT BDL CC-134 BELT DRIVE PART,CL DRIVE PLATE FIT #77012/77024 BELT DRIVES USE 4 BDL ECP-200 BELT DRIVE PART,CL HALF PLATE FIT #77012/77024 BELT DRIVES USE 2 BDL ECP-100