What are the symptoms of the p0011 code?
The camshaft phasers are stuck in the advanced position. What are the symptoms of the P0011 code? The ECM will turn on the Check Engine Light and command the camshaft to go to its normal starting position if possible. The engine may have a hard start condition if the cam is stuck in a too far advanced or retarded timing position.
What to do if your check engine light says p0011?
Check to see if there are any other codes along with P0011 and clear your Check Engine Light with FIXD. Check the engine oil level and condition. If it’s low, adjust to spec and test drive to see if the concern is resolved. If it’s dirty, change the oil and filter and test drive to see if the concern is resolved.
What is the code for check engine light?
This code will trigger the check engine light under the following condition: The comprehensive component monitor, referred to as the CCM, monitors the Variable Camshaft Timing (VCT) position for over-advanced cam timing.
What to do if your OBD code comes back?
Check the engine for it to be full of clean engine oil with the correct viscosity. The technician will scan and document the codes received and view the freeze frame data to see when the code was set. The codes should then be reset to clear the OBD-II fault codes and retest the vehicle to see if the P0011 code comes back.
What does trouble code p0011 mean on a car?
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be.
This code will trigger the check engine light under the following condition: The comprehensive component monitor, referred to as the CCM, monitors the Variable Camshaft Timing (VCT) position for over-advanced cam timing.
What is the trouble code for camshaft position a?
P0011 OBD-II Trouble Code: Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1) Cost of diagnosing the P0011 code. P0011 is a diagnostic trouble code (DTC) for “Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1)”.
What causes the Check Engine light to come on?
The comprehensive component monitor, referred to as the CCM, monitors the Variable Camshaft Timing (VCT) position for over-advanced cam timing. If the cam timing exceeds a maximum calibrated limit or is stuck in an advanced position, the check engine light will come on and set this trouble code.