What are the fault codes for the Thermo King?
Thermo King Alarm Codes & Fault Codes. Thermo King Straight Truck Units – Most Popular. # 1 MD 200. # 2 TS 300. # 3 TS 500. # 4 RD II- SR. Thermo King Trailer Units – Most Popular. # 1 SB-III SR.
How can I tell if my Thermo King alarm is defective?
Check for a defective 12-volt battery. This is more common than you would expect. When you turn on the unit, it loses power before engaging the starter. The screen may go blank or blink on and off. Use a voltmeter and verify that the battery voltage is correct (12V). Jump the starter and observe the battery voltage.
Why does my Thermo King Battery not cycle?
Answer: The most common cause for a unit not to cycle has to do with charging. Check the amp meter in your gauge menu if it is above 5 amps the unit will not shut off. If this is true your battery may be starting to fail.
How to troubleshoot alarm codes 10 and 20?
Trace the wiring circuit and check any fuses or switches connected to the circuit. This is one of the most common alarm codes you will encounter. Minus a few exceptions, you likely have a fuel system problem. The following troubleshooting tips should solve this problem quickly. Clear any alarms.
What are the most common causes of thermocouple measurement errors?
The following are the six most common causes of thermocouple measuring errors, followed by ways to rectify them: 1. Selecting the Wrong Type of Thermocouple on the Transmitter You can run into problems if you choose the wrong type of thermocouple when inputting the settings into the transmitter during installation.
Where can I troubleshoot my Thermo King alarm?
If you need help further troubleshooting your Thermo King unit, visit the Mobile Reefer Repair in Sacramento,CA. 204 issue redundant discharge air sensor 203 issue with redundant return air sensor 137 issue with damper motor heater output 136 issue with spare digital outputs 135 issue with spare digital inputs 134 controller power on hours
Why is my thermocouple not reading my temprel?
If finding that the thermocouple does not read, the problem is most likely a bad connection, broken wiring, or open internally within the thermocouple probe circuit. Inaccurate Readings?
Where can I get help troubleshooting my Thermo King?
If you need help further troubleshooting your Thermo King unit, visit the Mobile Reefer Repair in Sacramento,CA. Information for this article was sourced from Transport Refrigeration website.
What happens if you jump start a Thermo King?
Jump the starter and observe the battery voltage. If the starter fails to engage and the voltage falls to 1V or 0V, then you have a bad battery. Replace the battery. Warning: Any attempt to jump start the battery may cause it to explode. Check for a defective high-pressure cutout (HPCO) switch.
https://www.youtube.com/watch?v=Gn94xkJsU0I
When to report alarm on the Thermo King?
Manually monitor temperature. Report alarm at end of day. Report alarm at end of day. Report alarm at end of day. Report alarm at end of day. Manually monitor temperature. Report alarm at end of day. If unit/zone is shut down repair immediately. Otherwise, report alarm at end of day. If unit is shut down repair immediately.
How can I tell if my Thermo King Battery is bad?
Use a voltmeter and verify that the battery voltage is correct (12V). Jump the starter and observe the battery voltage. If the starter fails to engage and the voltage falls to 1V or 0V, then you have a bad battery.
Which is the most popular Thermo King trailer?
Thermo King Trailer Units – Most Popular. # 1 SB-III SR. # 2 SB- 210/210+. # 3 SB-310/310+. #4 SB 400. # 5 Spectrum.
Is the Thermo King Reefer in good condition?
Box Is A 2006 Great Dane, Flat Aluminum Floor, Rollup Door, All-Electric Unit Runs On 3PH 230V & 460V Service, Compressor Only Has 2 Hours On It, Good Tires & Brakes, DOT In Buyers Name. Excellent condition 2011 SB-310 unit. CARB evergreen with brand new RYPOS DPF system installed. call for details.
When to report alarm on a Thermo King?
Operator Action: Manually monitor temperature. Report alarm at end of day. Operator Action: If unit/zone is shut down repair immediately. Otherwise, report alarm at end of day. Operator Action: If unit is shut down repair immediately. Otherwise, report alarm at end of day.
What makes a Thermo King diesel refrigeration unit so good?
A complete line of self-powered diesel truck units that deliver lower cost of ownership through lower maintenance costs, improved fuel economy and unmatched reliability. The cornerstone of all Thermo King refrigeration units is reliability, and the T-90 Series continues the tradition.