What are the downstream O2 sensors on a Nissan?
One or two sensors will be downstream, B1S2 and B2S2. The procedure is similar for the downstream O2 sensors (Bank 1 & 2, Sensor 2). For the downstream sensors, you will find it easier to access the O2 sensor from underneath the car.
How do you remove the oxygen sensor from a Nissan?
The downstream oxygen Bank 1 Sensor 2 sensor has to be accessed from underneath the engine. You will need to remove the bottom splash shield. Disconnect the oxygen sensor electrical connectors. Press the connector and pull it away to unplug it from the oxygen sensor. Use an oxygen sensor wrench to remove the oxygen sensor.
What do you need to know about Nissan wiring?
These Nissan Wiring information / Aftermarket Autostart/Alarm Technical Wiring Diagrams are very useful, if not required, for the installation of alarms, autostart / alarms, remote starts, doorlock info and any other aftermarket installation that would require you to know the / Wire Information / Wiring Information of your Nissan
How do you check the fuse number on a Nissan 350Z?
Open the fuse box lid. On the fuse diagram, find the number of the fuse you want to check. The diagram tells you where to locate the fuse on the panel. Pinch the fuse perpendicularly with the fuse puller and pull it out.
One or two sensors will be downstream, B1S2 and B2S2. The procedure is similar for the downstream O2 sensors (Bank 1 & 2, Sensor 2). For the downstream sensors, you will find it easier to access the O2 sensor from underneath the car.
How do you replace the O2 sensor in a car?
Once you’ve replaced your vehicle’s O2 sensor, you’ll need to reset the ECU so it can properly gather information from the new O2 sensor. Open the fuse panel in the driver-side foot well, under the steering column, by pulling down on it with your fingers.
The downstream oxygen Bank 1 Sensor 2 sensor has to be accessed from underneath the engine. You will need to remove the bottom splash shield. Disconnect the oxygen sensor electrical connectors. Press the connector and pull it away to unplug it from the oxygen sensor. Use an oxygen sensor wrench to remove the oxygen sensor.
Once you’ve replaced your vehicle’s O2 sensor, you’ll need to reset the ECU so it can properly gather information from the new O2 sensor. Open the fuse panel in the driver-side foot well, under the steering column, by pulling down on it with your fingers.