Should you fill your oil filter?
An age-old question is whether or not you should pre-fill your new oil filter before installing it in your vehicle. The answer? Pre-filling the filter makes the process easier if you have a large, heavy-duty truck, but if you’re just changing the oil in a smaller car, it’s not necessary.
What’s the best way to do an oil change?
Make sure the cap, drain plug and oil filter are all secure. Start the engine (outdoors or in a well-ventilated area), let it run a few minutes, turn off the engine, and then let it sit. Check the oil level again. Top-off if necessary and check one more time for any possible leaks. Clean up any spilled oil.
How do you change the oil in a Briggs and Stratton car?
If the plug also serves as a fill cap (normally yellow or white in color), it may have two prongs so you can loosen it by hand or with a screwdriver or hex key for additional torque. Replace the drain plug by twisting clockwise and tightening with a box wrench or adjustable wrench. If your engine does not have an oil filter, skip this step.
What do I need to change my oil filter?
Get together your filter, wrenches, and other supplies. In addition to oil, you’ll need an oil filter, an oil-filter removal wrench, a wrench to remove the drain plug, a funnel, a drain pan and some gloves.
How often should you change the oil in a small engine?
For optimum performance, you should change the oil in your small engine after the first five hours of use and then annually, or every 50 hours of use (whichever comes first). Use Briggs & Stratton SAE 30W Oil above 40°F (4°C) for all of our engines. Check oil level regularly.
What are the steps in changing your oil?
Change Oil Yourself: The Oil Change Steps Warm up the engine. Find and unscrew the drain plug. Unscrew the oil filter and empty it. Attach the new filter. Screw the oil drain plug. Pour the oil and check the level.
How do you change oil at home?
Oil changes are pretty simple to do at home. If you’re changing the oil, you literally just slide under the car with a pan, remove the plug so that the oil runs into the pan, then go do something else. A while later, you put the plug back in place, open the top, and add oil until full. Done.
How do you change oil?
How to Change Oil Step 1 – Park your car on a level surface and apply parking brake. Step 2 – Jack your car up and place it on jack stands. Step 3 – Locate the oil drain plug and place the drain pan below. Step 4 – Unscrew the plug by hand. Step 5 – Drain all oil. Step 6 – Replace oil plug. Step 7 – Remove existing oil filter.
What is an oil change?
An Oil Change is the act of removing the used oil in your engine and replacing it with new, clean oil. Over time, oil breaks down and gets dirty. These factors make oil much less slippery and less effective at their job of lubricating engine parts.