Is there Cat C13 oil in the coolant?
CAT C13 OIL IN COOLANT. Hey guys. I have an engine here with so much engine oil in the coolant that rad is plugged. Tested the head gasket on the air compressor and there is a small leak, so we’ll replace the compressor. I removed the oil filter and pressurized the cooling system.
How much Oil can you put in a C13?
I used a 1R-1808 oil filter which is what Cat gave me and it fit fine but was a few inches longer than the Cat one that came off there. I put in nine gallons as a start and let it run, then shut it off and let it sit fifteen minutes. It was right at the full mark maybe a 1/16″ over actually.
What to do about engine oil in coolant?
I have an engine here with so much engine oil in the coolant that rad is plugged. Tested the head gasket on the air compressor and there is a small leak, so we’ll replace the compressor. I removed the oil filter and pressurized the cooling system. Water came pouring out of the filter housing, so I’m going with the oil cooler.
What’s the fuel economy on a Toromont ACERT C13?
Pulled strong and no issues at all. Whereas the bigger C15 ACERT’s had some issues, the service manager at Toromont Cat told me at the time there weren’t even any service bulletins on the C13’s. Lifetime fuel economy average on it was 5.3 MPG, whereas my new DD15 is 5.4.
Is it safe to use Caterpillar diesel fluids?
Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The warnings in this publication and on the product are, therefore, not all inclusive. You must not use this product in any manner different from that considered by this manual withoutfirst
Is it safe to use caterpillar lubricant on your car?
If a tool, procedure, work method or operating technique that is not specifically recommended by Caterpillar is used, you must satisfy yourself that it is safe for you and for others. You should also ensure that the product will not be damaged or become unsafe by the operation, lubrication, maintenance or repair procedures that you intend to use.
What causes coolant to enter the motor oil?
There are a few different tests to determine if the head gasket has failed. One of the more uncommon problems an engine can have is a cracked cylinder head or block. This usually occurs when the engine has been severally overheated and will allow coolant to enter the motor oil.
What can I use to clean oil out of coolant?
I use CAT cooling system fluid washer and works really really good. And it does the work incredibly fast. Fleetguard also makes a product that works great for cleaning the oil out of the cooling systme its called Restore. I’ve used it on my trucks and it does a great job.
Why is my Cat C13 engine leaking oil?
You can pull the injectors and with the piston at the top and bottom check for cylinder leak down. If the cylinder has scuffed it is possible the oil pump is torn up, it is also possible the oil filter is compromised.
What happens when coolant leaks from the oil cooler?
As with the above symptom, it’s important to contact a professional mechanic as soon as you notice a coolant leak. If enough coolant leaks from the radiator or oil cooler, it can result in engine overheating problems and mechanical component failure. 3. Oil in the cooling system
Can a bad oil cooler cause an engine to overheat?
If enough coolant leaks from the radiator or oil cooler, it can result in engine overheating problems and mechanical component failure. 3. Oil in the cooling system If the oil cooler adapter fails internally, you may notice engine oil in your cooling system.
Why is thorogh flush important when coolant is not running?
Because liners get coated with oil and dca will nkt stick to them anymore causing premature pitting. So a good thorogh flush is critical Just remember when engine was sitting not running coolant couldve went the other way also. If u had a leak that bad. A bearing check might be in your plan. (11-04-2016, 01:59 AM)Graglor Wrote: Hey guys.
Why is water pouring out of my oil cooler?
Water came pouring out of the filter housing, so I’m going with the oil cooler. Also removed the pan and pressure tested again to check for liner leaks and found nothing. So we’re going with an air compressor and oil cooler.