Is there a way to reset the fault on a can Am RT?
I have a “brake failure” fault and orange screen on a 2012 Can Am RT. The brake fluid appeared a little low so I filled it but still have the indication. Is there a way to reset the fault to see if it returns?
Are there any recalls on the can Am Spyder RT?
These issues include safety recalls for your Can-am SPYDER RT and complaints other owners have filed. What is Recall? A recall is when a product is removed from the market or a correction is made to the product because it is either defective or potentially harmful. What is Failure?
How to reset brake pedal on can Am Spyder?
The brake pedal traveled too far before there was enough pressure in the system. As you said you where afraid of. It is one of the few sticky faults that have to be reset. Turn the key on and wait until it fully boots up. Press down hard on the brake pedal and hold it. Turn the key off and wait until it completely shuts down.
Why do I get a brake failure message?
2011 rt. Brakes work great, Replaced rear brakes no problem, came back and bled brakes, failure message comes up! I think the mistake I made was turning the key to the on position.
I have a “brake failure” fault and orange screen on a 2012 Can Am RT. The brake fluid appeared a little low so I filled it but still have the indication. Is there a way to reset the fault to see if it returns?
When does a can Am Spyder brake failure occur?
It normally pops up after the bike has been ridden for a while and then stopped and then re-started (like a gas stop). It first occurred on the Blue Ridge Pkwy, after a scenic stop. Both brake reservoirs are topped off and the brakes work fine.
What does reset brake failure warning message mean?
I have a ride of over 1400kms round trip to my nearest dealer, a long way to go just for an error message reset. It appears to come on if I release the park brake and apply the foot brake gently immediately after. I rang my “local” dealer but he can’t help, other than the long ride.
How to reset brake failure warning message in Spyder?
-Wait 30 seconds. -Press firmly on brake pedal until you ear a clic from LPS switch or that you get 3500 kpa in system. P.S.: You will first hear the brake light switch. Continue to put more pressure until you hear a second clic that will come from the LPS.