Is there a warranty on Polaris Ranger 800?
Re-manufactured short block to fit all Polaris Ranger, Razor, Sportsman 800 EFI models Warranty Disclaimer: Our warranty will cover any defect in assembly or manufacturing including entire bottom end. With the best cylinder finish in the industry our warranty does NOT cover pistons .
How much does it cost to replace a Polaris Ranger engine?
These are the most expensive parts that we have to replace to build another motor. Crankcase being $979.99- cam and lifters $379.99- cylinder head $704.99 to replace these items for the next engine.
What kind of engine does Polaris Ranger have?
-Our engines are built with only the best parts and to factory spec and beyond factory spec. with new parts. All of our engines include NEW CRANKSHAFT, MAIN BEARINGS, COUNTER BALANCE BEARINGS, NEW CAM AND LIFTERS, REPLATED CYLINDERS, PISTONS, COMPLETELY REBUILT OIL PUMPS, NEW POLISHED OIL PRESSURE RELIEF VALVE WITH HONING OF RELIEF VALVE BORE…
What kind of Valve Service does Polaris Ranger use?
AND ALL OF OUR MOTORS ARE TOPPED OFF WITH A CNC VALVE SERVICE WITH NEW VALVES AND SEALS.
How to service a Polaris Ranger 800 XP?
Brake Switch 10.5 ELECTRICAL 10 9923499 – 2011 / 2012 RANGER800 Service Manual © Copyright 2011 Polaris Sales Inc. Ignition Key Switch 1. Disconnect the key switch harness by lifting the connector lock and pulling on the connector. Do not pull on the wiring. 2. Test between the 3 sets of outputs (OFF / ON / START).
How to replace AWD switch on Ranger 800 XP?
1. Disconnect the AWD / 2WD / TURF switch harness by depressing the connector locks and pulling on the connector. Do not pull on the wiring. 2. Test between the 3 sets of outputs (AWD / 2WD / TURF). If any of the tests fail, replace the switch assembly. • Move the switch to AWD. There should be continuity between switch pins 2 and 3; 5 and 6.
What are the parts of a Ranger 800?
PV-43568 Fluke™ 77 Digital Multimeter PV-43526 Connector Test Kit 2870630 Timing Light PU-50338 Battery Hydrometer 2460761 Hall Sensor Probe Harness 2871745 Static Timing Light Harness PU-47063 Digital Wrench™ Diagnostic Software PU-47471 Digital Wrench™ SmartLink Module Kit 10.4 ELECTRICAL
How to replace the ignition switch on a Ranger?
Ignition Key Switch 1. Disconnect the key switch harness by lifting the connector lock and pulling on the connector. Do not pull on the wiring. 2. Test between the 3 sets of outputs (OFF / ON / START). If any of the tests fail, replace ignition switch assembly.