Is the timing belt normal on a RD28?
The timing belt will move round at a different pace to that of the timing gears so what you experienced is normal. So is low power and high fuel consumption – it’s a RD28 ! Re check the timing and use a dti to set up the fuel pump, after that you’re into fitting go-faster parts – but don’t forget, it is a RD28…
What kind of camshaft does Nissan RD28 have?
After securing bearing cap bolts, make sure crankshaft turns smoothly by hand. The RD28 has a one-piece aluminum cylinder head with single overhead camshaft and two valves per cylinder: one intake and exhaust made of special heat-resistant steel. The camshaft is driven by a timing belt from the crankshaft.
Where are the timing marks on the belt?
TIMING MARKS.REMOVE TOP PLASTIC COVER TO ALIGN NUMBER 1 CYL. PUT ENGINE AT BOTTOM DEAD CENTER NO 1,AT END OF POWER STROKE. ALIGNMENT MARK ON CRANK PULLEY LINES UP WITH COVER BOLT LH SIDE. REMOVE CRANK PULLEY AND PLASTIC COVERS. EARLY BELT IS SEMI SQUARE AS SHOWN LATTER ENGINES HAVE SEMI ROUND TEETH.
Is the fuel pump on a Nissan RD28?
So is low power and high fuel consumption – it’s a RD28 ! Re check the timing and use a dti to set up the fuel pump, after that you’re into fitting go-faster parts – but don’t forget, it is a RD28…
The timing belt will move round at a different pace to that of the timing gears so what you experienced is normal. So is low power and high fuel consumption – it’s a RD28 ! Re check the timing and use a dti to set up the fuel pump, after that you’re into fitting go-faster parts – but don’t forget, it is a RD28…
After securing bearing cap bolts, make sure crankshaft turns smoothly by hand. The RD28 has a one-piece aluminum cylinder head with single overhead camshaft and two valves per cylinder: one intake and exhaust made of special heat-resistant steel. The camshaft is driven by a timing belt from the crankshaft.
So is low power and high fuel consumption – it’s a RD28 ! Re check the timing and use a dti to set up the fuel pump, after that you’re into fitting go-faster parts – but don’t forget, it is a RD28…
How big is the intake valve on a Nissan RD28?
Intake valves are 39.0 mm (1.54) in diameter, and the exhaust valves are 32.0 mm (1.26 in). The early Nissan RD28 engines were equipped with valve shims for adjusting the valve clearance, the later versions used self-adjusting hydraulic tappets.