Is the fuel pump on my Polaris Ranger a problem?

Is the fuel pump on my Polaris Ranger a problem?

As a sidenote this same problematic fuel pump is used in many of the fuel injected Polaris quads. If you own a Polaris ATV and you are having similar symptoms simply follow the same procedure for testing the PSI.

What should the PSI be on a Polaris fuel pump?

Here is what happens. After some usage the pump will wear and then drop from the factory PSI setting of 39 psi, to the low 30s. When your upper revs are sluggish you just aren’t getting any fuel. To test this install a fuel pressure gauge at your tank outlet.

Is the motor on my Polaris Sportsman still working?

Did an oil/filter change, had a little metal on the magnet, that happened at 8000mi, I sold the ATV w/15000mi. on and it’s still running. If you service the motors on your Polaris you’ll find that their the best part of the mach.. The clutches when they start to fail will do some strange things.

As a sidenote this same problematic fuel pump is used in many of the fuel injected Polaris quads. If you own a Polaris ATV and you are having similar symptoms simply follow the same procedure for testing the PSI.

Why does my Kohler command run out of gas?

The fuel filter always maintains gas. The float is moving freely and the bowl doesn’t run out of fuel, at least not when I remove the nut. That leaves the fuel pump itself, which was already looked at. Any suggestions?

What causes a carburetor not to work right?

This can be caused by either faulty gaskets on the carburetor or cracked or loose intake boots. While a carburetor is trying to make the right air and fuel mixture to deliver to the engine, it happens inside the carburetor which should be sealed without disturbance for it to work right.

Is there a fuel starvation problem on a Deere gt245?

A small tank of gas connected directly to the fuel pump would eliminate the tractor’s tank and fuel filter. I am having a similar problem with a Kawasaki 20 horse on a Deere GT245. Except mine doesn’t surge, it just runs for a short time and dies. Fuel pump and filter replaced, carb cleaned, fuel tank flushed out– no effect.

What to do if your Polaris Ranger doesn’t get gas?

For the most part, you should run into few problems if you properly maintain your Polaris Ranger. If your ATV does start to act up, you can perform some basic troubleshooting to get to the root of the problem. Examine the fuel system. Pull the fuel line and crank the engine to see if it’s getting gas.

Where does the fuel pump go on a Polaris Ranger?

Click to expand… If you pull the seat, the fuel pump mounts to the frame for the seat on the front . The hose comes from the tank to the pump then the inline filter then to the driver side to the carb. It is a black hose that is about 1/4 inch I.D. The fuel pump will have two wires to it.

Why did my Polaris Ranger backfire this weekend?

She has a 400 Ranger that has been rock solid dependable now for 3 years. This weekend it started to act up as far as just backfire a few times then die while going down the trail. We traced it down to a fuel problem.

How do you change fuel line clamps on Polaris Ranger?

Once you have the seat off, turn on the key and you will hear the pump run for a few seconds. The hose from the tank to the pump is where her problems were. It might be a good idea to just go ahead and get two fuel line clamps and change them out since they are easy to get to and you will be there anyway.