How wide is a Mustang GT rear end?
8.80 inches
A Ford 9-inch has a ring-gear diameter of, you guessed it, 9 inches closely followed by the 12-bolt at 8.875, with the Mustang rear at 8.80 inches.
What kind of rear end does a Ford Mustang have?
All 1979-1985 Mustangs featured the 7.5 rear end. Starting in 1986 Ford introduced the popular 8.8” rear end in the Mustang. From 1986-2010 the Ford Mustang 8.8 rear end went into all V8 Mustangs (5.0L, 4.6L and 5.4L) and the Ford 7.5” rear end went into all 4 cylinder (2.3L) and V6 Mustangs (3.8L).
Is the 94-98 rear end the same as the 99-04?
The 94-98 rear end consists of the same housing as the Fox, with axles that are .75″ longer on each side. The 99-04 rear end has a different, wider housing and that coupled with the longer axle increases track width by 1.25″ per side over a fox.
What’s the difference between a 1999 and 1999 Mustang GT?
Geared towards the pre-1999 Mustang GT owners, the “Power-Improved” engine can provide a noticeable increase in performance for less than the cost of rebuilding the original motor. For the 1999 Mustang GT, Ford made revisions to the intake manifold and cylinder heads to greatly improve flow and slightly raise the compression ratio.
How many axles does a Ford Mustang have?
The 2005-2010 V6 Mustangs with a Ford 7.5 rear end used 28 spline rear axles whereas the 2005-2010 V8 Mustangs with 8.8”rear ends used 31 spline rear axles. For 2011-2014 Mustangs, both the V6 and 5.0L V8 Mustang were equipped with 31 spline axles.
How big is the rear end of a Mustang?
Also, does anybody know what the measurement is on the 8.8″ rear end from the center of the axles to that of the flange the drive shaft mounts to? Also, how does like a 88 Ford Thunderbird Coupe 8.8″ rear end compare?
How big is the rear axle on a 79-93 Mustang?
– 94-95 spindles share the same track width as 79-93 spindles. – 96 and up spindles have an 8mm wider track width. – 79-93 Mustangs all use 9″ drums with 7.5 and 8.8 rear axles. – 4.0 liter Rangers use a wider 8.8 rear axle and 10″ drums.
What’s the gear ratio on a 1979 Mustang?
Use this guide to have your Mustang gear ratio explained! If you own a 1979 to current Mustang, then it came equipped with one of the two Ford rear ends – Mustang 7.5” rear end or the Ford Mustang 8.8” rear end.
When did the Ford Mustang get an 8.8 rear end?
Starting in 1986 Ford introduced the popular 8.8” rear end in the Mustang. From 1986-2010 the Ford Mustang 8.8 rear end went into all V8 Mustangs (5.0L, 4.6L and 5.4L) and the Ford 7.5” rear end went into all 4 cylinder (2.3L) and V6 Mustangs (3.8L). The 99-01 and the 03-04 Mustang SVT Cobras were equipped…