How to turn off front side marker lights?
Click to expand… You can easily do it by using a SPDT and a SPST relay. The SPDT relay would receive the blinker 12V signal and send it to the SPST relay, which could then tell the front side marker to turn off when activated.
How do you change the turn signal on a marker?
Tap the power wire on the turn signal and extend the wire up to the front side marker socket. Cut the wire YEL power wire for the front side marker socket and connect the extended wire to it. Cap off the exposed YEL power wire from the harness. Test, and you’re all set.
What kind of wire is front side marker light?
On the driver side and passenger side, the front side marker lights both use a YEL & WHT/BLK wire. The YEL wire is the power wire. The turn signal on the driver side also has a YEL & WHT/BLK wire. The YEL is the power wire. On the passenger side turn signal, the wires are GRN & WHT/BLK.
What happens to the side marker when the blinker is off?
When the blinker feed is on, the amount of current flow will be normal (through the blinker, but not through the side marker). Can it be that the ‘reverse’ current flowing into the blinker feed (as the ‘ground’ for the marker) when the blinker is off somehow confuses it when it is on?)
How do I replace the front turn light?
Locate the clips holding the inner fender liner in place and remove them. Pull the fender liner out so you can access the bulb housing. If you have a 1.8-liter engine, you’ll need to pull out the intake duct tube as well (on the driver side only). Turn the socket counterclockwise.
Is the front turn signal the same as the parking light?
Your car uses the same bulb for the front turn signal, parking light and side marker. Like the rest of the lights on your car, these will eventually burn out and need to be replaced. Here’s how to install a new one: You have to access both the driver and passenger side bulbs from the inside of the wheel wells.
How do I replace the front turn signal?
Locate the clips holding the inner fender liner in place and remove them. Pull the fender liner out so you can access the bulb housing. If you have a 1.8-liter engine, you’ll need to pull out the intake duct tube as well (on the driver side only). Turn the socket counterclockwise. Pull it out of the housing. Remove the old bulb.
How to change front turn signal and side indicator bulbs?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: Uw7HIPQsIRkroUhi)