How to turn off fog lights in Nissan Altima?
To turn the fog lights off, turn the fog light switch to the OFF position. The headlights must be on and the low beams selected for the fog lights to operate. The fog lights automatically turn off when the high beam headlights are selected.
How do you turn off the fog lights?
To turn the fog lights off, turn the fog light switch to the OFF position. The headlights must be on and the low beams selected for the fog lights to operate. The fog lights automatically turn off when the high beam headlights are selected. Turn signal 1 Move the lever up or down to signal the turning direction.
How do you install a fog lamp on a Nissan?
Plug the fog lamp harness into the connector at the back of the fog lamp. Plug the other end of the harness into the pre-wire vehicle harness connector. Secure the fog lamp harness to the fascia with the retaining clip as shown. 9. Carefully press the lower cover panel back into position.
Where are the fog lights on a car?
Bumper mounted fog lights are typically below the headlights. Check your vehicle manual if you have difficulty locating them. Disconnect the fog light switch from the housing. This disconnects the fog light from the vehicle’s power system. It should disconnect by detaching the clip. Remove the washer, bolt, and nut.
How do you install a fog light on a car?
Insert the bolt. Thread the washer and nut over the bolt, tightening with a ratchet or wrench. Do not over tighten as you may damage the fog light housing or the vehicle. The housing should be snug and immobile. Reattach the switch. Reconnect the fog light switch using the clip.
How to install fog lamp finisher on Nissan?
Begin on passengerside of vehicle. Locate the lower cover panels under the front fascia. Remove three (3) phillips head screws. Remove three (3) retaining clips. Set all fasteners aside for later reinstallation. 4. Carefully pry off the passenger side fog lamp finisher cover by depressing the retaining tabs on the inside of the fascia.
Do you have to drill new holes for fog lights?
If it does not, you may have purchased the incorrect headlights. Make sure that the bolt holes line up; otherwise you may have to drill new ones. Insert the bolt.
What are the restrictions on installing fog lights?
Check your local laws. Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation.
Can you wire a fog light to a fuse box?
At the fuse box it’s only a positive wire so when you put the fog light wire there. The factory switch can still be used to turn on and turn off the fog lights whenever you want. You can also wire it to a completely separate switch that allows you to turn them on independently whenever you want.
How do you turn on the fog light?
To turn the fog lights on, turn the headlight switch to the position, then turn the fog light switch to the position. To turn the fog lights on with the headlight switch in the AUTOposition, the headlights must be on, then turn the fog light switch to the position.