How to test the turn signal switch step by step?
TEST 1: Checking The Turn Signal Fuse Input. TEST 2: Checking Flasher Voltage Output. TEST 3: Flasher Voltage Input. TEST 4: Front Right Turn Signal Output. TEST 5: Rear Right Turn Signal Output. TEST 6: Front Left Turn Signal Output. TEST 7: Rear Left Turn Signal Output. Test Summary.
How do you reset the turn signal on a Dyna Glide?
Press left turn signal switch once, and light will flash a number of times to indicate an error code. There is 1.5 seconds between flashes to indicate 1st and 2nd digit of codes and four second pause between codes. Press and hold left switch down for five seconds, and light will flash twice to indicate the TSSM is reset. Turn ignition to off.
How does the turn signal on a Harley Davidson work?
The Turn Signal Security Module monitors the signals and the alarm system for the bike. When there is a problem, the red light key will illuminate. Diagnosing and clearing the codes on each module is really simple, as explained below.
What to do if your turn signal switch is bad?
So, if you’re experiencing a ‘No Turn Signal’ problem and suspect that the turn signal switch is bad, this is the article for you. You’ll be able to specifically test the following: No Front Left Turn Signals. No Rear Left Turn Signals.
What are the symptoms of a bad turn signal switch?
1. Turn signal indicator continues to blink when the steering wheel returns to the center. This symptom likely reflects a failure of the mechanical portion of the turn signal switch. Unfortunately, we’ve all seen drivers cruising straight down the road, with their turn signal still blinking.
How does a turn signal switch work on a car?
For example, if a left turn signal is selected, the turn signal switch will maintain a flashing left turn signal until the steering wheel is turned a certain amount counterclockwise (for a left turn), then turned clockwise back to a straight-ahead, or centered position. The same is true for a right turn.
Why is my left turn signal not flashing?
When it’s not working, there is no signal front & rear and no signal indicator either. When working, both markers function properly as does the indicator. With new bulbs installed and sockets cleaned, I’ve narrowed the problem down to either the left turn signal switch or the turn signal module.
Where is the turn signal module on a Street Glide?
Jonathan, sounds like you have a bad turn signal module. You will find this module between the fuel tanks, beneath your dash area. Thanks, and good luck Similar Question Been enjoying the videos and tips I have a 2008 Street glide with 90K miles on it. I always took it to the dealer until I found your website and got the premium membership.