How to reset the brake pad warning message?
Then press and hold until it says reset then release and press and hold again to reset the light. Hopefully that’s correct. Hey, so there is, thanks! I got thru the menu to the reset process and pressed reset, and it shows the timer..but then says ‘reset unsuccessful’.
What happens when you reset the brake service reminder?
When you carry out the procedure to reset the brake light a message will display on the instrument cluster stating “reset impossible”. If you have reset the brake service reminder for both the front and rear brake pads and the light remains on, the next step is to check the voltage going to brake pad wear sensor and read the fault codes.
How to reset your Brake Service Alert in your BMW?
Recently, I just received my front brake pad service alert on my BMW. It is triggered when there is about 2000km mileage left. On your iDrive, you will receive this alert to warn you about brake pad going to be worn out. To reset this alert after you had replaced your brake pads: 1) Press and hold the odometer button.
How to reset brake pad warning message 2010 F10 5 Series?
So..I can find loads of advice on how to do this on older 5 series but not f10. New pads and wear sensor all done. Can I reset via iDrive , or an ebay OBD scanner? If the latter, any advice as to which one to get? Thanks in advance.. Hi guys, not here much, as our f11 520d has been a faithful companion and a fine motorcar all round.
How to reset the brake wear sensor service warning indicator?
K. Use the BC Button (on indicator stalk) to scroll through to the relevant symbol – eg Rear Brakes. L. To Reset the warning indicator alarm – Press & Hold the BC Button at the relevant symbol until RESET appears – then press and hold again until the process is complete.
When you carry out the procedure to reset the brake light a message will display on the instrument cluster stating “reset impossible”. If you have reset the brake service reminder for both the front and rear brake pads and the light remains on, the next step is to check the voltage going to brake pad wear sensor and read the fault codes.
How to reset iDrive warning message after replacing brake?
2. Press the odometer reset button for between 5 and 10 seconds until a yellow triangle with an exclamation mark in the centre appears in the top window between the clocks (where the outside temperature / time or date normally appears) – this is the “Service” icon. 3.
Can you reset the brake wear reminder on a BMW?
Turn off the ignition and wait 10 seconds. Let’s say you replaced your BMW brake pads but are not able to reset the brake light. The most issue that will prevent you from reseting BMW brake wear reminder is becasue the pads on the axle with old pads are critically well as well.