How to reset check engine light after replacing mass air Flow sensor?
Re: Mass Air Flow Sensor Replaced – Check engine light still on! A way to reset the entire system is to unhook the battery (negative first, then positive) and leave it unhooked for about 10 min. Longer will not hurt anything.
How to fix P101 code?
The most common potential repairs to address the P0101 code are as follows: Verify the code with a scanner. Reset the fault codes and perform a road test using a live data scanner. If the P0101 code comes back, then follow the test procedure prescribed for that code.
What causes a Nissan Rogue to have p0101?
Nissan Rogue P0101 Causes Here are the most common causes of P0101 in the Nissan Rogue. They are presented loosely in order from most to least likely: MAF Sensor Dirty– Over the course of its life, the MAF sensor will often get so covered in grime that it’ll no longer get an accurate reading.
What does the MAF sensor on a Nissan Rogue mean?
Nissan Rogue P0101 Diagnosis: MAF Sensor November 10, 2018by Jason With the Nissan Rogue, P0101means the the Mass Air Flow (MAF) sensor has a Range/Performance problem. We will cover exactly what that means and potential fixes for it below.
Why do I keep getting a p0101 code in my 2011 Nissan Sentra?
I cleaned old maf sensor, put it back, and cleared the code. The code came back after a couple of days. Ordered a new maf sensor, it turned out to be remanufactured but I went ahead and replaced it anyway. I cleared the code and 2 days later, the same code came back. I cannot seem to figure out what the problem is. My car has 118000 miles.
How to check MAF sensor on Ford Ranger p0101?
Start by inspecting the wiring harness for obvious damage. If you don’t see any you can use a multimeter to test the wiring. At this point if you use the YouTube video above in the MAF sensor dirty section, and there turns out to be no voltage at all, try checking out How to Find an Electrical Short on Most Any Vehiclefrom BackYardMechanic
Nissan Rogue P0101 Causes Here are the most common causes of P0101 in the Nissan Rogue. They are presented loosely in order from most to least likely: MAF Sensor Dirty– Over the course of its life, the MAF sensor will often get so covered in grime that it’ll no longer get an accurate reading.
Nissan Rogue P0101 Diagnosis: MAF Sensor November 10, 2018by Jason With the Nissan Rogue, P0101means the the Mass Air Flow (MAF) sensor has a Range/Performance problem. We will cover exactly what that means and potential fixes for it below.
I cleaned old maf sensor, put it back, and cleared the code. The code came back after a couple of days. Ordered a new maf sensor, it turned out to be remanufactured but I went ahead and replaced it anyway. I cleared the code and 2 days later, the same code came back. I cannot seem to figure out what the problem is. My car has 118000 miles.
What is the sensor code on a 2012 Rogue?
After 100K miles my 2012 rogue started throwing code P0101, mass airflow. I replaced the sensor twice. Once with an aftermarket tensor once with OE part. ($230!!!)