How to replace headlight and fog light assemblies?
Replacing headlight and fog light assemblies follow nearly identical steps, and both are covered in this how-to. Disconnect the negative battery terminal so you don’t accidentally short out or blow fuses. Figure 1.
How do you remove a fog light from a car?
Use the screwdriver to pry the clip off. Remove the access panel to access the rear of the fog light assembly. Use the socket wrench to remove the two 10-mm bolts mounting the assembly to the car. Unhook the wiring module from the assembly. Push the rear of the fog light assembly forward to access the bulb.
How do you replace a fog light on a WRX?
Lay under the front bumper of the WRX and position your body so that you can physically access the rear of the fog lamp housing. Turn the bulb socket counterclockwise to remove the bulb and socket from the rear of the fog lamp assembly. Unplug the old bulb from the bulb socket and install a new bulb.
How do you change fog lights on a Santa Fe?
Return the parts to the Santa Fe in reverse order of removal. Close the hood, and try out the Santa Fe fog lights by turning them on from inside the vehicle. Insert a screwdriver into one of the two screws in the outer fog light cover. Twist out the screw counterclockwise to remove it; repeat this for the other screw.
How do you replace a fog light assembly?
The only real remedy is to purchase new fog/side light assemblies and lamps. First off, loosen off your wheel bolts. Then jack the car up, and support it with an axle stand. Now remove your wheel. Remove the large cover, and the screws holding the arch liner in.
How do you replace fog light on minitorque?
First off, loosen off your wheel bolts. Then jack the car up, and support it with an axle stand. Now remove your wheel. Remove the large cover, and the screws holding the arch liner in. Then pull the liner back. Unplug both the fog light and side light bulb holders from the wiring loom.
What are the restrictions on installing fog lights?
Check your local laws. Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation.
What do you need to know about fog lights?
Check your local laws. Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation. Choose your bulb type. There are three main types of bulbs available for fog lights.