How to repair parking brake cable on Hyundai Santa Fe?
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the parking brake cable mounting nut (A) and bolts (B). 4. Remove the parking brake cable adjusting nut (A) and the fixing clip (B), and then remove the parking brake pedal.
What should I do when I replace my handbrake cable?
When you fit the new cable, it’s well worth renewing any clevis pins that are grooved, as they will create a lot of slack in the linkage. Also fit new split pins. Where the cable passes through the yoke and the guide brackets, make sure it is well greased. When the cable is refitted, adjust it. Pull the cable away from the brake shoes.
How do you replace a parking brake cable?
Remove and replace parking brake cable. Adjust parking brake. Test parking brake. Always apply the parking brake when the car is parked. This will keep the parking brake adjusted properly. Your mechanic should inspect the parking brake cable during every brake service.
Where does the primary cable for the handbrake go?
The primary cable (where fitted) runs back from the handbrake lever to the equalizer yoke where the secondary cable or rod joins. First have a look at the primary cable to see how it fits. It may be attached to the handbrake lever either underneath or inside the car.
How much does it cost to replace a brake cable in a Hyundai Accent?
The average cost for a Hyundai Accent emergency brake cable replacement is between $339 and $405. Labor costs are estimated between $251 and $317 while parts are priced at $88. Estimate does not include taxes and fees.
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the parking brake cable mounting nut (A) and bolts (B). 4. Remove the parking brake cable adjusting nut (A) and the fixing clip (B), and then remove the parking brake pedal.
How does the parking brake cable work in a car?
The parking brake cable is held in a fixed position, and when the parking brake lever is pulled, pressed, or electronically engaged, the cable is pulled tight. For disc brake systems, this tension presses the rear brakes pads into the rear brake rotor, or, for drum brakes, the rear brake shoes will be pressed into the rear brake drum.