How to repair an OMC electric shift lower unit?
The following may be required if your electric shift lower unit has run in salt water for periods of time :Drill old hole 13/64 in aluminum 3/4 inch deep. Tap hole with #5401-4 helicoil 1/4 -20 inch thread
How is the swivel housing on an OMC sterndrive made?
Swivel housing is sand blasted and painted. Lower vertical seals 2 units that are offset to land on a different position on shaft in case of previous drive shaft wear. Prop shaft bearing retainer is machined to hold 3 seals that will locate in different position on the prop shaft.
Can a broken outdrive on an electric shift be repaired?
Trish can tig weld electric shift upper or lower gearcases do to impact damage for years 1967 to 1977 in most cases. Outdrives with broken skeg or lower unit aluminum top fin in most cases the sterndrive can be left together.
How to repair an OMC electric drive shaft?
Replacing or repairing forward or reverse spring, new drive shaft bearing, new seals, pressure testing. Swivel housing is sand blasted and painted. Lower vertical seals 2 units that are offset to land on a different position on shaft in case of previous drive shaft wear.
How to make a Shimano shifting lever work?
Furthermore, check that the shifting lever does not touch the bicycle frame when the handlebars are turned all the way. • Use an OT-SP cable and cable guide for smooth operation. • Grease the inner cable and the inside of the outer casing before use to ensure that they slide properly. Do not let dust adhere on the inner cable.
What do you need to know about gear shifting?
• If gear shifting adjustments cannot be carried out, check that the rear fork ends are aligned. Also, check if the cable is lubricated and if the outer casing is not too long or short. The actual product may differ from the illustration because this manual is intended mainly to explain the procedures for using the product.
What happens when you put inner cable on shifting lever?
Be careful not let the BC-9000 / BC-R680 inner cable come into contact with the shifting lever or the metal section (adjustment section) of the caliper brake. When the inner cable is installed, coating may be damaged and become fluffy; however, it will not affect the function. Note: