How to remove an alternator from a Pontiac Montana?
To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: tRuRX68ULZkYEfsV) An error occurred while retrieving sharing information. Please try again later.
Who is the owner of the 2006 Montana SV6?
2006 Pontiac Montana SV6 Owner ManualM GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem, and the name MONTANA are registered trademarks; and the name SV6 is a trademark of General Motors Corporation. This manual includes the latest information at the time it was printed.
How do you adjust the reclining seat on a Pontiac Montana SV6?
Reclining Seatbacks To adjust a seatback, pull up on the lever located on the outboard side of the driver’s or front passenger’s seats. Release the lever to lock the seatback where you want it. Push and pull on the seat to make sure it is locked into position.
When did Pontiac start using Hydra Matic Drive?
Adding Hydra-Matic Drive upped compression to 9.0:1 and horsepower to 180. For 1970, a bored-and-stroked version of the Pontiac big-block V-8 arrived. This 455 lasted through 1976. Initially it was not a real high-performance options, but it had huge amounts of torque and potential for development into a hot engine.
When to start the distributor on a Pontiac V-8?
The distributor must be timed appropriately to provide peak performance and that includes initiating combustion some 30 to 40 degrees before the piston reaches TDC, depending upon the application.
When did Pontiac stop using transistorized ignition system?
Many electronic conversion kits are available. Since the 1960s, Pontiac has used various ignition systems that were electronically triggered. Its Transistorized Ignition was eventually replaced by the Unitized Ignition System in the early 1970s.
To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: tRuRX68ULZkYEfsV) An error occurred while retrieving sharing information. Please try again later.
How do you remove an alternator from a car?
Once the belt is off just remove whatever bolts connect the alternator to the bracket and you’re good to go. Our model required the removal of three bolts: one at the front and two at the rear. With the old alternator in your hand you’re half way home.
How many bolts do you need to replace an alternator?
Our model required the removal of three bolts: one at the front and two at the rear. With the old alternator in your hand you’re half way home. You’ll likely find getting the new one back in goes much faster since you already know what size the bolt heads are and where everything is.
How to replace an alternator on a 1995 GMC?
Somewhere on your vehicle there is a tensioner pulley. You’ll need to move it enough to slip the belt off the pulley. Our ’95 GMC has a standard spring-loaded GM tensioner that required us to pull it back with a wrench.
What to do when your check engine light goes off on a Pontiac?
Insert the key into your Pontiac’s ignition, and turn on the vehicle. Look on the instrument panel on the dashboard to confirm the check engine light has gone off.
How do you clear engine codes on a Pontiac?
If you don’t have the time or feel confident working around the battery, you can have the codes cleared out with either an OBD-1 or OBD-2 scan tool, depending on the year of your Pontiac. Most auto parts stores have these scan tools and will clear the codes for you, free of charge.
What are the transmission problems on a Pontiac Montana?
Code indicated pressure control solenoid. Service mgr. indicated past experience was that solenoid sheds fragments that contaminate valve body. Engine/transmission must be suspended to remove cover and valve body for removal and cleaning. $100.00+ in parts but a ton in labor.
Why is my Pontiac Montana stuck in 4th gear?
Happens on highway when a hard shift is needed at a high speed to go up a hill. I pulled over and did not shut the van off and then tried to drive again and it was stuck in 4th gear. I pulled into a rest area, turned off the van for a while to eat (about 20 mins), then started it up and pulled back onto the highway.
Why does my Pontiac Montana make a whining noise?
My ’01 Montana has a “whining” noise that sounds like it’s downshifting, but it is not. The engine RPM stays constant. It seems to happen around 40 mph when I let off the accelerator, and goes away if I accelerate.