How to mount and secure a racing wheel?
For more information on how to mount and secure the G29 and G920 racing wheels using bolts, see Mount and secure the G29 or G920 racing wheel using built-in bolt mounting points. NOTE: You can also use the clamping system on the G29 or G920 to secure the wheel and pedal units.
How to mount a G29 racing wheel with bolts?
Please click on the appropriate links below for the mounting templates. For more information on how to mount and secure the G29 and G920 racing wheels using bolts, see Mount and secure the G29 or G920 racing wheel using built-in bolt mounting points.
Where does the mounting plate go on a controller box?
You have to figure the best method for securing that mounting plate somewhere under that top piece of the control panel. The layout on the panel does not really affect the design-type of the layering and mounting in the panel, which also does not really affect the design-type of the custom controller box.
How big are the bolts on a Sanwa joystick panel?
For many of the Sanwa and Seimitsu mounting plates, the placement of the bolts in a dimension of 85mm by 40mm or 80mm by 40mm will work. So if there is potential for changing the model of joystick in your panel at some point, you may want to install the bolts with approximately those dimensions. Mounting Types Bottom-Mounting
What kind of bracket do I need to mount an access point?
Using third-party accessories (not offered by Cisco) you can mount an access point above a suspended ceiling. The universal mounting bracket (AIR-AP-BRACKET-2) supports a T-bar box hanger such as the Erico Caddy 512A or the Cooper B-Line BA50a.
How do you mount an access point on a router?
See the “Grounding an Access Point” section for general grounding instructions. Step 6 Position the mounting bracket mounting holes (with indents down) over the pilot holes. Step 7 Insert a fastener into each mounting hole and tighten. Step 8 Connect the Ethernet and power cables to the access point.
What should I use to mount an access point on a ceiling?
Caution Do not use plastic wall anchors or the keyhole slots on the mounting bracket for ceiling installations. When mounting the access point on a hard ceiling, use four fasteners capable of maintaining a minimum pullout force of 20 lbs (9 kg).
Where to mount a Cisco Aironet access point?
These mounting instructions describe the steps for mounting supported Cisco Aironet series access points in several configurations, including on a suspended ceiling, on a hard ceiling or wall, on an electrical or network box, and above a suspended ceiling.