How to heat blend a Jeep Wrangler door?
Pics of the actuators and what it controls along with actuator motor on newer TJ. Disconnect the actuator and see if it turns if you turn the temp knob. (older TJs uses the slide bar mechanism and just pull the assembly out to inspect the connections) Wattapunk thanks for the diagrams. I get heat, just does not seem the same as it has been.
Can you watch Jeep Liberty blend door troubleshooting on YouTube?
(Playback ID: W1EgUGZX3mD3wXcC) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Where does the Heat Blow Out on a Jeep Liberty?
Heat blows out on passenger side but not drivers side, cold air is blowing out of drivers side , doesn’t matter if it’s on defrost floor or dash all cold, got me stumped Answered! View the answer I have this problem too
What kind of heater does a Jeep Liberty have?
The second generation (KK) Jeep Liberty, a compact 4-door SUV that restored the classic sharp lines of the original Jeep styling. Heat blows out on passenger side but not drivers side, cold air is blowing out of drivers side , doesn’t matter if it’s on defrost floor or dash all cold, got me stumped
How does a blend door work on a Jeep Liberty?
I got the dash pulled out far enough to remove the blend door actuator and had a new one to put in it, but i discovered that the blend door itself only moves less than a quarter turn and jams. Won’t go to hot. Not sure exactly how the blend door works.
Can you repair a jeep kJ blend door?
Discussion in ‘ KJ General Discussion ‘ started by tdm5032c, Feb 1, 2020 . I’ve researched this and found quite a few posts on the blend door actuator and how to replace it, but does anyone know how to repair or replace the blend door itself?
Why is my Blend door stuck in the closed position?
My blend door got stuck/jammed in the closed position due to over travel. Probably when the bottom gear broke. This is a very expensive fix as the whole dash needs to come apart to replace the whole blend door unit. I took the plastic hvac ducting leading to the floor out of of the blend door unit.
How to replace the HVAC blend door actuator?
Unplug the heater resistor, and the vacuum line going to the vent direction actuator. I’d pull the tube off the vac reservoir mounted to the dash and toward the passenger side door. There is another connector down there that I never did id that must be disconnected. Nothing really appeared hidden.