How to disable the seat belt chime on a jeep?
1. Sit in car with everything off and buckle seatbelt. 2. Press ignition button until you get to RUN position. 3. Wait for display console seatbelt icon to go off. 4. Unbuckle and buckle 3 times, ending with it buckled again. 5. Press ignition button until you get to OFF. Do not start the car at any time.
When did the Jeep Grand Cherokee seat belts stop latching?
I bought this Jeep in March on 2012 , then few months after buying it the drivers seat belt stopped latching unless i depressed it to make it latch then a month or so later the passengers seat belt started doing the same thing. But since then the seat belt chime started going off and the seat belt light on the dash started staying on too.
How much does it cost to put a seatbelt on a Jeep Grand Cherokee?
In order to check it is a $69.00 fee. Then the order is made and the $69.00 is deducted from your total bill of approximately $497.00. You have to purchase the whole unit and not just the seat belt. The seatbelt will latch when you hold down on the red button and then shove into the slot.
Why does my Cherokee SRT8 chime when I buckle?
At first the passenger seatbelt was hard to get buckled unless you press the red release button first while buckling. Then it developed into chime was continuous, where anyone was in the seat and the belt was buckle it failed to recognize it was buckled. Therefore the chime would continue chiming 13 times before cycling off.
How to fix seat belt chime on Jeep SRT8?
2. Turn the ignition key to the ACC/ON position (engine does not need to be running), and wait for the seat Belt Warning Light to turn off. 3. Within 60 seconds of starting the vehicle, unbuckle and re-buckle the driver’s seat belt at least 3 times within 10 seconds, ending with the seat belt buckled. 4. Turn the ignition to the OFF position.
How do I Turn Off the seat belt chime?
1. Turn ignition to the OFF position and buckles the driver’s seat belt. 2. Turn the ignition key to the ACC/ON position (engine does not need to be running), and wait for the seat Belt Warning Light to turn off.
At first the passenger seatbelt was hard to get buckled unless you press the red release button first while buckling. Then it developed into chime was continuous, where anyone was in the seat and the belt was buckle it failed to recognize it was buckled. Therefore the chime would continue chiming 13 times before cycling off.