How to connect dashcam to aftermarket stereo head unit?
Click to expand… hehe i think it depend on the car model / make, but in my little Suzuki i can take apart the center console rip out the double DIN headunit, run around the car 3 times and put the head unit back in the console and reassembly everything in 30 minutes, and all it take is a Phillips head screw driver.
What to do with a new dashcam?
When i get new dashcam and install it i will also take a little time to document how different things in the car can be overcome, hopefully that video will be to some use for people willing to DIY but just afraid to get going and ruin something. Every one should know the inside of my little red lightning when i am done.
Where can I get a double DIN head unit?
In other markets such as Mexico the 100 was available with a standard double DIN head unit but the wiring harness is significantly different from the NAV equipped vehicles in the USA to make a swap non trivial. A project is under way to develop solutions for navigation equipped vehicles.
Click to expand… hehe i think it depend on the car model / make, but in my little Suzuki i can take apart the center console rip out the double DIN headunit, run around the car 3 times and put the head unit back in the console and reassembly everything in 30 minutes, and all it take is a Phillips head screw driver.
How to remove Dash Radio from Toyota Corolla?
1. Pry open the trim panel with the installation tool. 2. Remove the original car CD around the panel. 3. Unplug the connectors. 4. Remove 4 screws from the original CD player. 5. Remove the original car CD and disconnect the connector. 6.Check all Belsee accessories of new car radio and connect.
When i get new dashcam and install it i will also take a little time to document how different things in the car can be overcome, hopefully that video will be to some use for people willing to DIY but just afraid to get going and ruin something. Every one should know the inside of my little red lightning when i am done.
How do you install a new car stereo?
1. Please pull out your car key and off the car. 2. Prepare installation tools and electronic insulation tape. 3. Make sure the car battery is full. Because the new car stereo requires 12 Volts. The navigation system doesn’t turn on if your car doesn’t have enough 12volts. 4. The wires must be connected and covered with electronic insulation tape.