How to check codes on 93 honda del sol?
Jump the small two pin connector located underneath your passenger side dash/carpet by the ECU. Just use a small piece of wire, or a paperclip. A long blink is 10, a short blink is 1. The keys should be in the ign., but you don’t need the car running.
How do you find the trouble code on a check engine light?
The check engine light will flash as normal. Count the number of flashes to determine the applicable CEL code (trouble code). A long flash (or approximately one second) equals 10. A short code (or approximately half a second) equals one. For example, two long flashes followed by two short flashes will equal to the code 22.
What happens if your check engine light goes off?
It sends data to the vehicle’s computer, which uses it to regulate the mixture of air and fuel that enters the cylinders. An engine will keep running even if an O2 sensor needs to be replaced, but it will burn more fuel than usual. In the long run, a bad O2 sensor can damage components like the spark plugs and the catalytic converter.
Why does my Saab check engine light keep coming on?
When your Saab check engine light stays on, it means that the On-Board Diagnostic (OBD) computer has detected a malfunction. The cause could be an engine problem, a fuel system leak, or even an indication of a transmission issue. Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes.
Can a check engine light be combined with an ABS warning light?
In some cases, it is possible to have a check engine light combined with an ABS/TCS warning light. This issue is usually caused by an ABS/TCS unit internal problem, causing a communication error. The only real solution is to remove the ABS/TCS control unit from the car and send it to a specialist for repair.
The check engine light will flash as normal. Count the number of flashes to determine the applicable CEL code (trouble code). A long flash (or approximately one second) equals 10. A short code (or approximately half a second) equals one. For example, two long flashes followed by two short flashes will equal to the code 22.
Why is my Check Engine light coming on and off?
Intermittent check engine light. Comes on for a while and then goes off. Cannot link it to any vehicle activity. The contact owns a 2003 SAAB 9-3. The contact stated that the vehicle jerked when the brake pedal was depressed and stalled. The check engine warning light illuminated. The vehicle was able to restart.
Why does the Check Engine light come on on my Saab 9-3?
Comes on for a while and then goes off. Cannot link it to any vehicle activity. The contact owns a 2003 SAAB 9-3. The contact stated that the vehicle jerked when the brake pedal was depressed and stalled. The check engine warning light illuminated. The vehicle was able to restart.
Is it safe to drive with check engine light on?
Sometimes, multiple sensors send signals, indicating clues that something bigger has gone awry. You can still drive with the light illuminated, assuming the car is running and driving fine, but you should get it checked out as soon as possible.