How to change the brake light on a Honda Civic?
This video shows you how to change the brake lights on your 2012 Honda Civic. When you replace the brake light bulb on your Civic, be careful not to touch the bulb directly with your fingers – the oil from your skin will cause the area that you touched to burn hotter than the rest of the bulb, which causes the bulb to burn out quicker.
What should I do if my Honda Civic breaks?
An error occurred. Please try again later. (Playback ID: UMgKxrDdV6iRvOfj) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
Where is the brake warning light on my car?
In most vehicles this switch is located in the master cylinder. You’ll see a harness plug in somewhere around there. Some vehicles will now activate the brake warning light on the dash if the actual brake lights behind it go bad. Check to see that both of them are lighting up.
Why does my brake light only come on when I press the brake pedal?
You’ll feel a loss of pressure that manifests itself in the form of a “mushy” brake pedal. If the brake light is only coming on when you push the brakes, that’s a definite indication that the pressure in the brake system is too low. Either the brakes need bled, or there is a leak.
This video shows you how to change the brake lights on your 2012 Honda Civic. When you replace the brake light bulb on your Civic, be careful not to touch the bulb directly with your fingers – the oil from your skin will cause the area that you touched to burn hotter than the rest of the bulb, which causes the bulb to burn out quicker.
How do you replace the tail light on a Honda Civic?
Quarter panel tail lights: Insert the new tail light assembly into the rear quarter panel. Secure the tail light with all four 8mm bolts. Plug in the wire harness to the tail light bulb socket. Repeat these steps with the other side. Reconnect the negative (black) battery terminal, and test the new tail lights. Figure 7.
An error occurred. Please try again later. (Playback ID: UMgKxrDdV6iRvOfj) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
In most vehicles this switch is located in the master cylinder. You’ll see a harness plug in somewhere around there. Some vehicles will now activate the brake warning light on the dash if the actual brake lights behind it go bad. Check to see that both of them are lighting up.