How to calculate head bolt and cam bearing cap torque?
Hi, Below are cam bearing and head bolt torques and sequences: Cam: Clean and inspect the camshaft bearing caps in the cylinder head. Lubricate the lobes and journals of the camshaft prior to installation. Install the camshaft and the bearing caps. Tighten the camshaft bearing caps to 86 inch lbs. (9.8 Nm), in sequence.
What are the torque specs for a Honda CRV?
I need head bolt and cam bearing cap torque specs for a 2000 Honda CR-V 2.0l I need head bolt and cam bearing cap torque specs for a 2000 Honda CR-V 2.0l – Answered by a verified Mechanic for Honda We use cookies to give you the best possible experience on our website.
How to tighten cam bearing cap on CRV?
Fig. Fig. 1: Camshaft bearing tightening sequence- CRV models Set the camshafts at Top Dead Center (TDC) for No. 1 piston, align the holes in the camshafts with the holes in the No. 1 camshaft holder and insert a 5mm pin punch into the holes.
How big should the cap be on a camshaft?
Tighten the camshaft bearing caps to 86 inch lbs. (9.8 Nm), in sequence. See Figure 1 Fig. Fig. 1: Camshaft bearing tightening sequence- CRV models
Do you need head bolt and cam bearing cap torque specs?
I need head bolt and cam bearing cap torque specs for a 2000 Honda CR-V 2.0l – Answered by a verified Mechanic for Honda We use cookies to give you the best possible experience on our website. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policyunless you have disabled them.
I need head bolt and cam bearing cap torque specs for a 2000 Honda CR-V 2.0l I need head bolt and cam bearing cap torque specs for a 2000 Honda CR-V 2.0l – Answered by a verified Mechanic for Honda We use cookies to give you the best possible experience on our website.
How to tighten cylinder head and cam bearing cap?
Install the keys into the keyways on the camshafts and install the pulleys, then tighten the retaining bolts to27 ft. lbs. (37 Nm). Install the timing belt. as outlined in this section. Cylinder Head: Tighten the cylinder head in two steps following the illustrated sequence: Step 1: 22 ft. lbs. (29 Nm) Step 2: 63 ft. lbs. (85 Nm)