How to activate or deactivate the light feature or adjust?
Activate the Light Feature 1 Close the garage door. 2 Start with the garage door opener lights “ON”. 3 Press and hold the light button for 10 seconds. (Upon pressing the light button, the lights will immediately turn off… More …
Is there a way to turn off the light?
Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes.
How long do you hold the light button?
Press and hold the light button for 10 seconds. (Upon pressing the light button, the lights will immediately turn on and go off 10 seconds later.)
How can I control the light on my door?
In addition to operating the door, you may program the remote to operate the lights. With the door closed, press and hold the small remote button that you want to control the light. Press and hold the Light button on the Multi-Function door control. While holding the Light button, press and hold the Lock button on the door control.
How to turn off the webcam light / led?
To turn off the light, you will need to turn off the webcam. If you want to turn it off: 1. Go into Control Panel. 2. Click on Hardware and Sound. 3. Click on Device Manager. 4. Go to Imaging Devices, and double-click on the webcam entry that appears below it. 5. Go to the Driver tab, and click Disable. Confirm it if asked to do so.
How do I Turn Off the location light?
Rather than using the Location tile on the Action Center, let’s fully turn it off and back on via the Location Privacy Settings panel. Step 1: On the Start menu, type Location, and then select Location Privacy Settings on the search results. Step 2: On the Location Privacy Settings panel, turn off the switch next to Location Service.
How to reset a motion light that stays on all the time?
Check the time switch to confirm it isn’t set in “Test” mode. If set in “Test” mode, move the switch to a pre-determined time setting. The “Test” mode could cause the light to come on and remain on. Reset the light to make sure it isn’t set to manual operation. Turn off the light switch that operates the motion light.
Why is my Night Light not turning off?
Another problem that crops up is when Night Light keeps on staying enabled even outside the time that it’s schedule to actually run. And obviously, turning it off doesn’t disable it either.