How much torque does a strut bolt need?
Torque the strut to knuckle bolts to 63 ft/lb. Torque the top strut top nut to 41 ft/lb. check front wheel alignment, adjust camber etc as needed.
How tight should a strut mount be?
You should leave them just about snug, if not just a little loose. If you tighten them before you put it on the ground, when you do get the car on the ground, there will be tension on the parts, which means it will wear quicker.
Can you over tighten strut mounts?
Any nut or bolt which is over tightened is essentially over stretching the bolt, or in this case the strut tube. This can lead to premature failure of the strut and require early replacing. Over tightening also compresses the spring down further on the strut, causing preload to the spring.
How tight should you tighten front shocks?
you dont need to torque the old post top shock, ones with two rubber washers and the nut. Just tighten the nut down till the rubber washer is just starting to squish, then go about 5 turns more. kinda in the middle of when it starts to squish and before you totally colapse it .
Can a strut mount make noise?
Although this component is often overlooked, the suspension system can’t function properly without it. A damaged strut mount can cause strange noises, poor handling, and overall ride discomfort.
How do you replace the struts on a Toyota Corolla?
Use a large wooden log if you have to. Take off the lug nuts ( 21mm socket) and pop off the wheel. Put the car’s scissor-jack under the ball joint to hold it up when you remove the strut. Remove the brake hose clamp from the strut using a 14mm wrench. Next, you will want to remove the sway bar. This has a 17mm nut and a 6mm hex Allen driver inside.
Where to find torque specs for struts?
2. Shouldn’t we re-torque the top 3 nuts to 59 ft lbs after the car is lowered to the ground? Since the nuts will carry the weight of the car, after it is lowered, the torque might be less than 59? 3. Similarly for the end links, we should just torque it to something like 15 ft lbs. Then at the end, drive it up a ramp and torque it to 29, correct?
How much ground clearance does a Toyota Corolla have?
*1: Ground clearance of front wheel center *2: ground clearance of lower suspension arm front bolt center *3: ground clearance of axle beam set bolt center *4: ground clearance of rear wheel center Service data Torque specification
What should I do about my Toyota Corolla front suspension?
Be careful not to get liquid refrigerant in your eyes or on your skin If liquid refrigerant gets in your eyes or on your skin. wash the area with lots of cool water. Cautio Resistance measuring condition of electronic parts unless stated, all resistance is measured at an ambient temperature of 20 c (68 °F).