How much psi can a K04 turbo handle?
K04 is good till around 310 to the wheels.
How much boost does a K04 make?
I have seen some k04 cars boost up to about 1.5bar, or 21.7 PSI.
How much PSI does a ko4 Turbo have?
The K04 will do 1.85 bar (~27psi) only not for a very long time. It is better to get the results from ignition and normal (20-21 psi) boost pressure. You can expect 375-385 HP if there is enough fuel (hpfp).
Is 20 psi boost good?
20 psi is fine. its the boost spikes that hurt. you can max out a k03 on stock internals no problem, but controlling the spike is difficult because the turbo is a pea shooter. and yes it will diminish the life of the turbo, depending on how you drive it.
How much boost can a k03 turbo handle?
about 12 psi with any sort of efficiency.
How do I know if I have a K04 turbo?
Registered. You can tell by the color, If its (Blue) its a K00, If its (Red) its a K01, If its (Green) its a K07, and if its (Gamboge) its a K04 not to be confused with (Fallow) Which is the color usedto signify a supercharger.
How much boost can a k03 handle?
How big is a K04 turbo?
On the turbine side, the OEM K04 uses a 50.1mm inducer and a 44.5mm exducer 12-blade cast wheel. The CST4 uses a 56.2mm inducer and 49mm exducer high-flow 9-blade design. Again, the CST4 outshines the K04 with the turbine inducer being 12% larger and the exducer 10% larger.
What MM is a K03 turbo?
KKK K03 Turbo charger Turbine Wheel Shaft Indcer:45.03mm Exdcer:40.50mm | eBay.
What is the boost pressure on a 2001 Jetta?
When I got my car running properly again my boost was in around 10 -15 psi fairly consistently. I drive a 2001 Jetta, in my shop manual the stated boost pressure is 1700 to 2200 mbar under load.
What is the normal boost pressure on new turbo?
The book has a note in it stating (1000 mbar is used for zero reference which is = to 14.7 psi the pressure at sea level or 0 gauge Pressure). So I think the pressure would be 700 to 1200 mbar gauge pressure. I think 1200 mbar = 1.2 bar.
Which is better corksport turbo or K04 Turbo?
The CorkSport turbo also sports a performance journal bearing with a full 360° thrust collar, which is what allows the turbine shaft and compressor to spin freely. The OEM K04 turbo comes standard with a limited 270° thrust collar. Does The CST4 Have Increased Airflow Over The K04? Next comes wheels, which is where the CST4 really shines.
What’s the boost level on a K03 GTI?
Click to expand… Agreed with this. According to the maps I have on this, 22+ psi would be the boost level at a certain engine air flow rate (3000revs) that is still shown on the K03 compressor map 180,000revs to 200,000 revs. Rev that motor to 5500- 6000 revs and you find you are off the compressor map both for compressor speed and efficiency.