How much does Kia Optima transmission fluid cost?

How much does Kia Optima transmission fluid cost?

The best part is, our Kia Optima Automatic Transmission Fluid products start from as little as $6.99. When it comes to your Kia Optima, you want parts and products from only trusted brands.

How does a trans fluid temp sensor work?

It the varies its internal resistance in relation to transmission fluid temperature to send a return voltage signal to the PCM. TFT sensors are a type of negative temperature coefficient (NTC) thermistor. This means internal resistance of the sensor is inversely proportional to the oil temperature.

What kind of fluid does a Kia Spectra use?

Use the fitment form at the top of the page to select your exact year and engine type for your Kia Spectra. Automatic transmission fluid is a technologically advanced, low viscosity formulation specially designed to deliver performance and maximum fuel efficiency for modern automatic transmissions.

When does the TFT sensor signal go down?

The TFT sensor signal voltage goes down when the transmission fluid temperature goes up and vice versa. Code P0713 is set when the PCM detects a high transmission fluid temperature sensor signal. This usually indicates an open circuit.

It the varies its internal resistance in relation to transmission fluid temperature to send a return voltage signal to the PCM. TFT sensors are a type of negative temperature coefficient (NTC) thermistor. This means internal resistance of the sensor is inversely proportional to the oil temperature.

The TFT sensor signal voltage goes down when the transmission fluid temperature goes up and vice versa. Code P0713 is set when the PCM detects a high transmission fluid temperature sensor signal. This usually indicates an open circuit.

How to test transmission fluid in a car?

To accurately test the system, you’ll want to refer to the manufacturer’s diagnostic flow chart. Use a scan tool to monitor the transmission temperature sensor data parameter. Disconnect the TFT sensor; the scan tool value should drop to a very low value. Next, connect a jumper wire across the terminals.