How many keys are in Ford anti theft system?
B1213: Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103 :Transceiver internal antenna damaged.
What is the name of the theft deterrent module?
VATS, Passkey, & Passkey II – resistive chip ignition key Vehicle Anti-Theft System (VATS) – VATS has a separate module called the Theft Deterrent Module (TDM) that validates the resistive chip in the ignition key.
What does passive anti theft system stand for?
Passive Anti-Theft Systems (PATS), also called Ford Securilock, is a vehicle security. feature introduced on 1996 and later Ford vehicles.
How often does the Pats theft indicator flash?
PATS Theft Indicator flashes every 2 seconds at Ignition OFF. This is normal operation for PATS to act as a visual theft deterrent. (See chart on reverse side for applicable system.) PATS Theft Indicator stays on for 2 or 3 seconds (depending on system type) at Ignition RUN or START and then off. This is normal operation for PATS prove out.
What are the different types of GM anti theft systems?
GM made several different types of anti-theft systems. VATS, PassKey, and PassLock. The troubleshoot and reset procedures are different for each. PassLock seems to have the highest failure rate. So if you have a key WITHOUT a chip in it, chances are it’s a PassLock system.
What do you need to know about Nissan anti-theft system?
Overview of the Nissan Anti-Theft System (NATS) This Website provides information needed for the purchase of key codes, immobilizer reset codes and the equipment needed to prepare the products needed to gain access to a vehicle and programming needed to facilitate the starting of the vehicle.
How does an anti theft system work on a car?
This system uses a coded lock cylinder. That’s right, the coding is built into the lock so if a thief pulls the lock cylinder they’ll never be able to start the vehicle. When you insert the proper key and turn the cylinder, a magnet on the cylinder induces a magnetic field onto a sensor.
What do I need to replace my theft deterrent system?
Lost or broken keys must be replaced with a key of the same resistive value. Get a key made at the dealer or a qualified locksmith. This system does not need to be reset if the PCM is replaced. This system also has a Theft Deterrent Module (TDM) but it’s programmed in to the body control module (BCM).