How long does it take to swap a 4L60E transmission?
Someone has to know the exact condition of your car to answer this question. The estimated time is about 8 hours. To rebuild the transmission is an additional 6 hours.
Can a 4L60E be used without a computer?
Externally, all it needs is a 12-volt source and an engine-vacuum reference. However, if your trans is, in fact, a 4L60E, running it off a computer is mandatory. Never mind TCC lockup; without a computer, the trans won’t shift at all.
How many hours does it take to swap a transmission?
It can take a bit longer depending on the level of damage. Some professional technicians complete the entire replacement task in two or three hours.
Is there a problem with the 4L60E transmission?
Just like any other transmission, 4L60E can also experience problems and might require an upgrade. For better performance, get automatic transmission rebuild kits. Here are 3 symptoms of a failing 4L60E transmission and how to diagnose the problems: No Third Gear – You put the vehicle in drive, start off the transmission, and shift to second gear.
What’s the difference between a 93 and 94 4L60E?
1994: Interchangeable with ’93 4L60E with no modifications. The ’93-’94 is a NON PWM transmission. This means that the lock up apply strategy is an on /off arrangement. It has an 11 pin case connector.
How much fluid does a GM 4L60E need?
The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.
Why does my 4L60E make a horrible noise?
Horrible noise in 4th and feels like the brakes are on: overrun clutches are applying due to a cracked or leaking forward piston. Overrun clutches will be worn out after 30 seconds of this behavior. Car can be safely driven in D. Transmission must be removed and rebuilt.