How long does it take to reset readiness code?
The vehicle should be driven approximately 7.5 miles within a period of approx. 23 minutes (1372 seconds) from a cold start. However, due to manufacture variations, it is necessary to perform only as much of the Drive Cycle as is necessary to reset the required monitors to a “Ready” status. Operate the throttle smoothly to obtain best results.
How to set readiness codes for Honda Accord?
1. Connect the HDS to the vehicle’s data link connector (DLC), and bring up the READINESS CODEs screen for Catalyst in the DTCs MENU. 2. Start the engine. 3. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise.
When to reset the OBD2 readiness monitor status?
Readiness monitors read with the Android app. The vehicle doesn’t support readiness monitors for this drive cycle. Clearing the diagnostic trouble codes (DTCs) and the Check Engine Light will reset the monitor statuses too. This typically occurs during or after vehicle repair. Statuses are also reset in case of power failure.
When do you change the readiness code on your car?
Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise. During the drive, decelerate (with the throttle fully closed) for 5 seconds. After about 3.5 miles (5.6 km), the readiness code should switch from incomplete to complete.
The vehicle should be driven approximately 7.5 miles within a period of approx. 23 minutes (1372 seconds) from a cold start. However, due to manufacture variations, it is necessary to perform only as much of the Drive Cycle as is necessary to reset the required monitors to a “Ready” status. Operate the throttle smoothly to obtain best results.
How to check readiness code on Honda Acura?
Honda/Acura , from the owner’s manual, to check if the readiness codes are set, turn the ignition switch to the ON (II) position, without starting the engine. The MIL will come on for 20 seconds. If it then goes off, the readiness monitors are set. If it blinks five times, the readiness monitors are not set. Drive Cycles to Reset OBD II Monitors
Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise. During the drive, decelerate (with the throttle fully closed) for 5 seconds. After about 3.5 miles (5.6 km), the readiness code should switch from incomplete to complete.
How to check the readiness of a Honda Accord?
To check the status of a specific DTC system, check the OBD status in the DTC MENU with the HDS (see page 11-8). This screen displays the DTC, the current data list of the enable criteria, and the status of the readiness testing. NOTE: – During the procedure, do not turn the ignition switch to ACC (I) or LOCK (0).