How long does it take to remove gas tank on C50T?
It should take about 5 minutes to actually remove the tank. You said your bike is different, but here’s what it takes for a C50T (assuming stock seat): It is best if there is very little gas in your tank. 1. remove the bolt at the back of the passenger seat; pull the passenger seat back and out of the passenger strap at its front.
How do you remove a gas tank on a motorcycle?
It is best if there is very little gas in your tank. 1. remove the bolt at the back of the passenger seat; pull the passenger seat back and out of the passenger strap at its front. 2. remove the two bolts that hold the bracket that secures the passenger strap / rear of the front seat; remove the bracket and pull the front seat back and out.
Can you loosen the clamp on the turbo inlet?
Take a bolt that slides in and adhere the clamp stopping the coolant. This is a good time to loosen the turbo inlet clamp to the turbo while you are in the neighborhood. There is one breather hose from the passenger side valve cover that needs to be disconnected from the hard line on the right side of the inlet. Turbo clamp hiding back here.
Where is the fuel line on a TGV?
Remove the feed, return and evap line from the driver’s side hardlines. The brake booster vacuum hose is located near these and can be disconnected from the manifold. With the air pump removed you can now undo the fuel line clamps and hoses. Or you can used the fuel line tool to unclip them from the hardlines.
How do you replace a fuel line on a scooter?
The others are fairly easy to remove. If you are just replacing the fuel line, pull the tank up just enough to get access to the fuel tap. If you are doing both the fuel and oil, you’ll want to pull the tank up further to get access to the bottom of the oil tank. Here we see the fuel tapat the bottom of the tank.
How do you replace the fuel line on a Vespa?
Now you get to remove the fuel tank. Pull up on the back of the tank. The Rally tanks are larger than most of the others, so you will have to manhandle it a bit to get it out on the Rally. The others are fairly easy to remove. If you are just replacing the fuel line, pull the tank up just enough to get access to the fuel tap.
How to remove a Cub Cadet gas tank to replace the fuel?
There are only 6 bolts holding the cowling on, plus you’ll have to take the seat, brake pedal and drive pedals off. Easy Peasy on this Cub Cadet 2166 riding lawn mower! Once the cowling is off, you can easily access the gas tank and then pull the old fuel line out. Make sure you pay close attention to how the old gas line is run.
How to remove a Gen 3 gas tank?
Once you have as much gas as possible removed it’s time to take out the backseat and disconnect the supply line. Press the tab on the 5-pronged plug (mine is a 1996 Gen3, others may be similar) and remove it – easy… Next remove the fuel supply line; the large nut is 19mm and the small one is 14mm I believe.