How long does it take to fix an ignition switch?
How long does it take to replace an ignition switch? Generally, an ignition switch replacement takes about 20 minutes providing that the mechanic or the individual performing the repair has all of the vital and necessary parts for the fix and the other parts have been recovered.
How to reset ignition PassLock on a 2003 Saturn Ion 3?
If the Passlock system does not automatically reset, it can be reset manually. Turn the ignition key to the “Start” position as if you are starting the engine. Turn the ignition key to the “Run” position after two to three seconds. Leave the key in this position for 10 minutes.
What happens when you turn the ignition key on a Saturn?
If the battery is known to be fully charged, the Saturn should start. If there is an error in the ignition switch, you will not hear the typical faint “click” when you initially turn the ignition key to the “III” position to crank the engine.
Where is the fuse on a Saturn ignition?
Open the fuse panel under the steering column by turning the knob on the fuse panel counterclockwise and pulling down on the cover. Locate the fuse for the starter in the fuse panel using the fuse diagram on the underside of the fuse panel cover. Remove the fuse using a fuse puller in the fuse box.
What should the circuit resistance be on a Saturn Ion?
There’s an open in the circuit resistance is above 200 ohms and a loose terminal or a faulty module if below 200 ohms. Measure the resistance between the crankshaft position sensor’s terminals A and B. (Disengage the DIS module’s five-pin connector first). The resistance should be 700 to 900 ohms.
If the Passlock system does not automatically reset, it can be reset manually. Turn the ignition key to the “Start” position as if you are starting the engine. Turn the ignition key to the “Run” position after two to three seconds. Leave the key in this position for 10 minutes.
How does the ignition switch work on a Saturn?
Saturn vehicles use a transponder inside the ignition key to prevent unauthorized engine starting. There is a component inside the dash and linked to the ignition switch that sends a signal to the starter motor allowing the vehicle to start.
What should I do if my Saturn ignition is not working?
Turn the ignition key and try to start the engine. If the battery is known to be fully charged, the Saturn should start. If there is an error in the ignition switch, you will not hear the typical faint “click” when you initially turn the ignition key to the “III” position to crank the engine.
There’s an open in the circuit resistance is above 200 ohms and a loose terminal or a faulty module if below 200 ohms. Measure the resistance between the crankshaft position sensor’s terminals A and B. (Disengage the DIS module’s five-pin connector first). The resistance should be 700 to 900 ohms.