How long do Volvo struts last?
Struts and shocks may need to be replaced anywhere between 50k and 100k miles. If at any time the struts or shocks are leaking, broken, or damaged, they should be replaced immediately. Lastly, they should always be replaced as pairs.
Do struts affect ride quality?
Struts also perform a second job. Unlike shock absorbers, struts provide structural support for the vehicle’s suspension. As a result, struts affect riding comfort and handling, as well as vehicle control, braking, steering, wheel alignment and wear on other suspension components, including the tires.
How long do cheap shocks last?
In general, a shock absorber should last at least 50,000 miles before you need to have it replaced. However, the real determining factor is where you drive and how you drive. For instance, if you do a lot of off-road driving, or spend a lot of time on dirt roads, your shocks will wear out much more quickly.
Is it time to replace my shocks and struts?
Another reason you may want to replace your shocks is if you want better performance from your car. As originally equipped, most cars have relatively compliant suspensions. By installing a set of high-performance shocks, you will improve the handling and sometimes even the ride quality.
How do you remove a front strut on a Volvo?
While on the alignment rack and doing the alignment, you remove the front upper strut nut (holding the upper strut plate to the body), then take a hammer and pound the stud out of that plate.
What causes a Volvo front suspension to be negative?
If the top of the pivot is leaning toward the rear of the car, then the caster is positive, if it is leaning toward the front, it is negative. If the caster is out of adjustment, it can cause problems in straight line tracking.
How tall is the front suspension on a Volvo?
This can cause a ride height difference diagonally, where the left rear corner, for example, is low, the right front may actually be high. Volvo recommends that ride height be checked at each of the four jack point bars and that it not vary by more than 1/4 to 3/8 inch from one corner to the next.