How does the cruise control work on a Jaguar?
In certain conditions, such as a steep gradient, the vehicle’s speed may exceed the set cruising speed. This is because engine braking is unable to maintain or reduce the vehicle’s speed. Driver intervention may be required. The Cruise control system is operated by controls mounted on the steering wheel.
How to switch between cruise control and automatic speed limiter?
LIM: Press to switch between Automatic Speed Limiter (ASL) and Cruise control systems. These systems cannot be used simultaneously. The Cruise control warning lamp will illuminate when Cruise control is active. See CRUISE CONTROL (GREEN).
How does the set speed work on a Jaguar?
Dependent on the vehicle’s specification, the set speed will be displayed as a marker on the speedometer or a numeric display in the Message centre. The set speed can also be displayed in the Head Up Display (HUD), if enabled. See HEAD-UP DISPLAY (HUD). The cruising speed can also be increased using the accelerator.
How to cancel cruise control on a Jaguar?
Press ( -) to decrease the set speed. CAN: Press to cancel but retain the set speed in the system’s memory. Cruise control will also be cancelled if the brake pedal is pressed, the gear selector is moved to Neutral ( N ), or if the Dynamic driving mode is activated. See DYNAMIC.
Why do I get a warning message on my Jaguar?
Displayed when the engine has defaulted to limp home mode. The air suspension system is too low. Start the engine and wait for the message to clear before driving the vehicle. If the message is displayed while you are driving, restrict your speed until the message is cleared. If the message is persistently shown, inform your Jaguar Dealer.
What causes a Jaguar cruise control light to keep appearing?
What can cause a Jaguar cruise control light to keep appearing along with blown headlights? A faulty internal regulator on the alternator or a defective positive and negative battery cables can likely cause this issue. Perform a voltage drop test on the cables to find out which one is at the fault to replace, as needed.
What is the readiness code for Jaguar cruise control?
P1111 is a readiness code wherein no repair is needed. First, inspect the sensor on the black wire for a ground signal from the module. Then, make sure the brown wire has a pulsed voltage on it when spinning the wheel. Finally, check the ring on the rear axle for any looseness or damage.
In certain conditions, such as a steep gradient, the vehicle’s speed may exceed the set cruising speed. This is because engine braking is unable to maintain or reduce the vehicle’s speed. Driver intervention may be required. The Cruise control system is operated by controls mounted on the steering wheel.
What does c1165 mean on Jaguar cruise control?
C1165 indicates a fault with the passenger rear wheel speed sensor. Check the sensor for any faults with a voltmeter. Then, verify if the link harness to the sensor is broken. If so, replace the harness; or else, change the sensor. P1111 is a readiness code wherein no repair is needed.
Dependent on the vehicle’s specification, the set speed will be displayed as a marker on the speedometer or a numeric display in the Message centre. The set speed can also be displayed in the Head Up Display (HUD), if enabled. See HEAD-UP DISPLAY (HUD). The cruising speed can also be increased using the accelerator.