How does the climate system work on a Honda Accord?
According to the Service Manual, the Climate Control system runs through the Multiplex Integrated Control System. Before the AC is tested, Honda will connect the vehicle to their HDS computer to determine if the fault is with the MICS before they test the AC system. Testing the Air Mix motor also requires a trip to the dealer.
Is the driver’s side of the accord blowing warm air?
I have a 2007 accord and it is blowing outside air on the driver side, even when temp is set to maximum. The passenger side works fine though (blows warm air). Similarly, when I switch on the AC, the passenger side blows cool air, but the driver side blows ambient air from the outside.
What was the problem with my Honda Accord in 2007?
Answering the original question, how to fix cold air or hot air coming out of vents, even when the setting is the opposite. I had the problem on my ’07 Accord, dual temp controls in the EX-L. The problem is with the “air doors” that control the hot/cold air mix flowing into the cabin.
What are the parts for a Honda Accord?
Google these parts: driver’s side is: 79160-SDA-A41 passenger side is: 79170-SDA-A41 It was easy to find a fix video on YouTube, only took 30 minutes. Basically have to remove the trim, need a short philips screwdriver and a basic ratchet set.
How do you turn off air vent in Honda Accord?
The LED should flash on and off as you press the button. Turn the ignition and the fan switch to the “OFF” position. Set the temperature control dial on Max Cool. Push the mode control button and select Vent. Turn on the ignition.
Where is the mode control motor on a Honda Accord?
Locate the mode control motor. The mode control motor changes how air travels through the system, depending on which mode you’ve selected. It is on the driver’s side under the instrument panel, and on the left of the heater case. The blower motor is on the right of the heater case. The mode control motor should be parallel to the left fender.
How to do a self diagnostic on a Honda Accord?
Set the temperature control dial on Max Cool. Push the mode control button and select Vent. Turn on the ignition. Press and hold the recirculation control button. While holding the button down, press the rear window defogger button five times within 10 seconds. The recirculation indicator should blink twice, and then the self-diagnostic will begin.
Where is the blower resistor on a Honda Accord?
Locate the blower motor resistor. It is underneath the glove box. You will see a brown plug and several blue connections coming out of it. Push on the tab, and pull plug out of the resistor. Use a Phillips screwdriver to unscrew the two mounting screws. The resistor should fall right out.