How does a bypass module in a car work?
The Bypass Module Makes The Car’s Computer Think A Key Is In The Ignition. When you ask your vehicle to remote start, our bypass module sends a signal to the vehicle computer that it understands as a valid key, and it lets the engine start and keep running.
Do you need a bypass module for remote start?
If your vehicle was manufactured after the year 2000 and your key has a transponder, then YES you do need a bypass module for remote start. If you’re not sure if your vehicle falls into this category (and it likely does) don’s worry, your installer will be able to advise you.
Do you need a bypass module for immobilizers?
When immobilizers were introduced, aftermarket remote starters had to be installed alongside one of your expensive vehicle keys, or the factory security features had to be disabled entirely. Then came the bypass module to bring back the magic of keyless entry and remote start.
When to ask enormis mobile specialties about a bypass module?
When Enormis Mobile Specialties is talking to clients about a remote starter, the subject of a bypass module, or transponder module, often comes up. As we are getting to know the client better, they will often ask the question:
How does a GM PassLock bypass system work?
Every GM security system works on this one simple principle: The Key/Lock component sends an input signal to the TDM/BCM through the wiring. When the TDM gets the right input signal, it produces an output signal that allows the engine to start. That’s all it does. Because the Resistor is NOT a Passlock Bypass!
Can a PassLock bypass disable the fuel injectors?
The PRO Module is a FULL Passlock Bypass Module instead that goes right to the heart of the problem and solves it by reproducing the proper output signal that the PCM (onboard computer) uses to enable the fuel injectors. This means you can disable and often remove the ENTIRE immobilizer system from your car, to plague you no more!
Is the Pro module a PassLock bypass module?
The PRO Module is a FULL Passlock Bypass Module instead that goes right to the heart of the problem and solves it by reproducing the proper output signal that the PCM (onboard computer) uses to enable the fuel injectors.
What to do when engine stall Idle Stop?
Aim for the little air bypass holes in the throttle opening. Use the small plastic tube that attaches to the nozzle on the aerosol can to aim the cleaner directly into the bypass port (s). Let the cleaner soak for at least 10 minutes before giving it another blast of cleaner.