How do you turn on the gas on a pocket bike?
Stand the bike upright; you should be sitting on the bike. The pull start cord is on your right side. Turn the gas valve in the vertical position opening the gas to the bike (as shown in image2 with yellow arrow, the gas valve in the UP position).
How do you adjust the idle speed of a carburetor?
When it’s at running temperature, find the 2 screws on your carburetor that adjust the air and fuel mixture. You can then use a screwdriver to adjust both screws ΒΌ turn at a time until your engine purrs smoothly. To adjust your idle speed, find the idle mixture screw that limits the flow of fuel at idle.
How to start a mini chopper pocket bike?
Put the choke lever in the closed position (as shown in image2 with red arrow, the lever in the UP position). Pull the start cord out slowly until it reaches its maximum distance, allowing the gas to flow into the bike. Repeat 2 times. On the 3 rd attempt, pull the cord quickly with the intention of turning the bike on.
How do you adjust the throttle on a pocket bike?
To do this, you can adjust the throttle cable slack via the tensioner on the throttle grip box. Simply slip off the rubber dust boot / sleeve and loosen the tension ring by hand (no tools necessary) and turn clockwise until you get your desired speed.
Where are the adjustment screws on a carburetor?
On most carbureted cars, the air cleaner housing is attached directly to the carburetor. Find the adjustment screws on the front of the carburetor. There should be two screws on the front of the carburetor, which are used to adjust the air and fuel mixture.
Put the choke lever in the closed position (as shown in image2 with red arrow, the lever in the UP position). Pull the start cord out slowly until it reaches its maximum distance, allowing the gas to flow into the bike. Repeat 2 times. On the 3 rd attempt, pull the cord quickly with the intention of turning the bike on.
How does the carburetor work on a bike?
This stops the gas from flowing around the bike, which in turn prevents the carburetor from flooding in the future. If you would like to go the extra mile and have your bike last longer than normal for future use:
Where to put choke lever on pocket bike?
In certain weather conditions, you may put the choke lever in the middle or lower position to help make it easier to start. Starting may require several tries when the bike is still new. After break-in, the bike will start up with only one or two pull procedures.
To do this, you can adjust the throttle cable slack via the tensioner on the throttle grip box. Simply slip off the rubber dust boot / sleeve and loosen the tension ring by hand (no tools necessary) and turn clockwise until you get your desired speed.