How do you tie the end of a belt?
Step 1: Wrap the belt around your waist, and slip the end of the belt through the belt loop, pulling until it fits comfortably. Step 2: Wrap the end underneath the belt then up again towards you. Step 3: Push the end back through the buckle again, and tighten as desired. Easy!
How do you secure D ring?
Pass the strap through both D-rings, then round and through the centre of the first D ring and pull it tight to fasten. This forms a tight slip-knot around the D rings which is infinitely adjustable and very resistant to pulling: pull the helmet away from the head and the strap tightens against the D rings.
How do you tie a belt with two rings?
Thread the ring-less end completely through both rings. The end is now facing left. Fold back the end so it faces right and hold it over the first ring it crosses, the leftmost ring.
What’s the best way to fasten a belt?
Their method of fastening may not seem instinctual at first, but with some practice and a bit of dexterity, getting these belts to fit together should be no problem. Put the end of the belt without rings through the belt loops or around the waist, starting at the left hip and ending with the rings on the left and ring-less end on the right.
How do you tie a belt on a trench coat?
Draw both ends of the belt to the front. Position the buckle frame at the point where the coat overlaps, and leave the tail end long. Thread the tail up through the buckle frame, towards the front. Guide it back down under the other side of the frame.
Where do the rings go on a belt?
Adjust the belt so the 2 rings are centered below your belly button. Pull on the end of the belt or the rings themselves to reposition the rings. Make sure they are on top of the top button at the front of your pants. The rings go in the same place that a standard belt buckle would go.