How do you take the back seat out of a Volvo v40?
Rear seats: lift up base cushions and unbolt the hinges, remove from car. Undo the hinge bolts at the bottom of the backrests, release seat locking catches and lift from car. Undo the single bolt at the base of the side bolsters and lift up the bolster to release the top hook, remove from car.
How do you take the back seat out of a Volvo xc90?
- Move the seat(s) to their rearmost position (seven-seat models only).
- Pull the loop to fold down an outboard head restraint. Press down the center head restraint if necessary (see page 109).
- Pull the handle (1) outward to release the backrest. The backrests are designed to lock at a 45 degree angle.
How do you take the back seat out of a Volvo v60?
Indeed, to achieve this, you just have to unscrew the two nuts at the back of your seat, accessible from your trunk, using a Torx bit. Then unscrew the two nuts at the front of the seat, which are located under the seat at the level of the passenger footwell.
How do you fold the second row in a Volvo XC90 2008?
To fold down the backrest:
- Push down the head restraint manually.
- Pull the strap on the right side of the center seat.
- Fold the backrest down until it locks into position. The seat cushion will move downward/forward when the backrest is folded down and create a flat surface.
How to replace the backrest on a Volvo V70?
Rear Seat: To remove the rear backrest, start by removing the side cushion. Pull it out toward the front (red arrow) then up to remove it. Then, remove the 13mm seat belt fastener (green arrow). Rear Seat: Working at the side of the seat, locate the locking clip (red arrow).
What is the part number for a VW rear seat release latch?
The part number is 1J0-885-643-E, you will also need the color code, for black the color code is B41, Grey is U71, Beige is Q70. The parts department should be able to help you out using the part number listed above.
What to do if rear seat release latch has broken?
Once it releases, completely pull that piece out. That is the piece you will be replacing (known as the rod). In the picture below, you will notice how one of the prongs has broken off the end of the rod. That is what has been keeping the latch from releasing the seat.
How do you remove the back of a car seat?
With the seat all the way back, remove the outer trim piece. Unclip the tab (red arrow) and slide it off toward the front of the vehicle (inset). Front Seat: Next, remove the two 13mm mounting fasteners (red arrows) at the seat rails.