How do you set up a brake controller on a Voyager?
Press on the brakes and hold them down. Rotate the level knob counter-clockwise until the light starts to change from green to red. Rotate it the other way until it appear orange. Dim orange is a normal setting, bright orange is an aggressive setting, and dim red is the most aggressive setting.
How do I test my tekonsha Voyager?
To bench test a brake controller you need to connect the black wire from the Tekonsha Voyager Trailer Brake Controller # 39510 to the positive terminal of a 12 volt battery and the white wire to the negative terminal. Then ground the test light to the negative terminal as well.
What is a Voyager XP?
Proportional brake control with Raybestos Voyager XP keeps your stops smooth! These electric trailer brake controls employ a patented brake sensor to keep your stopping power relative to your pedal pressure for controlled, secure stops. And Voyager XP delivers 100 percent full stopping power faster!
How do you adjust a tekonsha Sentinel brake controller?
Slowly rotate the Level Knob clockwise until RED color just shows, and then carefully turn the Level Knob back counter-clockwise until the solid GREEN color is just visible. 5. Once the brake control has been leveled such that the Bi-Colored Level Indicator Light shows GREEN, release the foot pedal.
Can electric trailer brakes be wired backwards?
Question: Are the magnets polarity sensitive? Trailer electric brake magnets are non-polarized. When installing an electric brake assembly, like the Electric Trailer Brake Assembly, Left Hand # AKEBRK-35L, either wire can be used for the brake signal and the ground wire, it will not matter which wire is used for which.
How do I know if my tekonsha brake controller is working?
Check that the light on the top right of the controller is green. If the light is not green, the controller is not connected to the trailer or there is no power or ground to the controller. Check that the trailer’s electrical connector is fully seated in the tow vehicle’s receptacle.
What is a Tekonsha Voyager brake controller wiring diagram?
Tekonsha Voyager Electric Brake Controller Wiring Diagram – wiring diagram is a simplified tolerable pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the power and signal associates surrounded by the devices.
Where do I connect the Tekonsha brake controller?
Connect the pigtail-style wiring harness included with the purchase of the Tekonsha brake controller to the back of the in-cab controller unit.
Who is the owner of the Tekonsha logo?
CONTROLLER + PLUG/PLAY WIRE KIT. Tekonsha ®, the Tekonsha ® logo, and Tekonsha ® graphics are the servicemarks, trademarks, or registered trademarks owned by Horizon Global Corporation. All other servicemarks, and trademarks are the property of their respective owner.