How do you reset the perform service light on 2006 Jeep Liberty?
How to Reset Perform Maintenance on a Jeep Liberty
- Turn on the engine.
- On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
- Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.
How to reset Jeep Liberty check engine code?
Tighten the bolt on the negative cable using the adjustable wrench until the cable end is tight and does not move on the post. Start the engine to ensure that the “check engine” light is no longer illuminated. Marc Lucas has worked in the education publishing industry since 2000.
Where is the negative battery on a Jeep Liberty?
It is located on the driver’s side directly behind the headlight. Loosen the bolt on the negative battery cable using the adjustable wrench and remove the cable from the negative post. Leave the cable unhooked from the battery for three to five minutes. Press the negative battery cable end onto the negative post.
Where is the DLC on a Jeep Liberty?
Open the driver’s side door of the Jeep Liberty and locate the diagnostic link connector (DLC) under the dash. It is located to the right of the steering wheel on the Liberty. Plug the pocket scanner into the DLC and then turn the ignition key to the accessory position. This will power up all the electrical controls without the engine running.
How do you reset a Jeep Liberty Battery?
Loosen the bolt on the negative battery cable using the adjustable wrench and remove the cable from the negative post. Leave the cable unhooked from the battery for three to five minutes. Press the negative battery cable end onto the negative post.
Tighten the bolt on the negative cable using the adjustable wrench until the cable end is tight and does not move on the post. Start the engine to ensure that the “check engine” light is no longer illuminated. Marc Lucas has worked in the education publishing industry since 2000.
How do you clear a code on a Jeep Wrangler?
To erase a code, use a scanner tool to remove that specific code. To dump all codes, remove the battery cable for 10 minutes, then reconnect. If you want to erase the adaptive memory completely and set the ECU to a new start up, remove the cable 10 minutes, reattach the cable and turn the key to the run position.
What is the diagnostic code for a jeep check engine light?
Refer to our Generic OBD II code list for definitions on all other Jeep diagnostic trouble codes. Manufacturer Specific Codes P1105Open Or Shorted Condition Detected In The Baro Read Solenoid Control Circuit – Read Our Article on Automotive Circuit TestingFor Help With This Jeep Check Engine Light Code P1192Inlet Air Temp. Circuit Low
What does the Mil light on a Jeep Liberty mean?
This simplified the process of diagnosing faulty sensors or modules in the vehicle that communicate to the vehicle’s computer system. When a faulty DTC is detected in the Jeep Liberty’s computerized system, it will trigger the “Check Engine Light” (also known as the malfunction indicator light or MIL), indicating an engine code has occurred.