How do you reset the oil life on a Jeep Cherokee?
Push and hold the OK button until the oil light percentage changes to 100%. Press the Start/Stop button to turn the electronics off. After these steps have been performed, you have successfully reset the oil life on the Jeep Cherokee If you are unable to reset the “Oil Change Required” light utilizing one of these methods, repeat the steps.
How to do an oil change on a Jeep Wrangler?
Use the NAVIGATION button (located on the steering wheel) and select VEHICLE INFO. Find the REMAINING OIL LIFE. Finally, hold down the OK button until the “Oil Life” display changes to 100 percent. Turn the ignition off and start the engine to verify the indicator has been reset.
How to reset a service light on a 2006 Jeep Grand Cherokee?
Put the Grand Cherokee’s ignition key into the ignition and turn it to “Run.” Don’t start the engine. Locate the “Step” button on the Grand Cherokee’s instrument panel and press it. Press it again until it says “Miles to Service.” Press in and hold the button for about five seconds. It should read “Reset.”
How to reset the service button on a Cadillac Grand Cherokee?
Press the gas pedal to the floor slowly three times within 10 seconds. Turn the ignition off. Wait 10 seconds and start the engine. If your vehicle is an older model Grand Cherokee, press and hold the reset button for 10 seconds while the engine is turned off but the key is in the “ON” position. How to Reset a Cadillac’s “Service …
How to reset the oil service light on a Jeep Grand Cherokee?
fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset Turn off the ignition, then start the engine normally and the light should be reset. About Jeep Grand Cherokee The Jeep Grand Cherokee is a range of mid-size SUV’s produced by the American manufacturer Jeep.
How do I reset the oil service light?
The oil reset is complete. YOU CAN ALSO RESET THE OIL LIFE USING THE TUTORIAL BELOW. Close all doors. Set the gear to the PARK position. Turn ignition to RUN position, don’t start the engine. Turn off the ignition, then start the engine normally and the light should be reset.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
How often should I Reset my Jeep ECM?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management. Good luck with your reset and be sure to share this with anyone that might be in need of it!